STI · KIT-M02002

STI KIT-M02002 Clear Frame for Stopper II Electric Strike

• Clear polycarbonate construction allows strike status inspection without removing cover.
• Mounts directly over Stopper II assembly using four fixing points drilled into masonry.
• Draws no independent power; operates at 9V DC through existing access control circuit.

STI · KIT-E18151

STI N.C. Reed Switch and Magnet for STI-SA5000 - KIT-E18151

• Replacement N.C. reed switch restores door-state detection on STI-SA5000 locks.
• Operates at 9VDC and integrates directly with HID reader-based access control panels.
• Kit includes both switch and magnet; maintain alignment within 0.25 in. for reliability.

STI · NT-CA100-EN

STI NoTouch® Cast Aluminum Switch with Three - NT-CA100-EN

• Infrared hand-wave trigger (1.5–6 in.) eliminates mechanical wear in high-traffic entries.
• Form C relay (0.5A@120VAC / 1A@24VDC) integrates directly with EM locks and strike panels.
• Three included snap-in lenses enable zone labeling without hardware swaps on retrofit installs.

STI · NT-SS000-EN

STI NoTouch® Stainless Steel Switch Slim/Mullion - NT-SS000-EN

• Infrared detection (4–15 cm range) enables hands-free door release with zero contact.
• Form C relay (1A @ 24VDC) drives electric strikes, maglocks, or gate operators directly.
• IP65-rated 304 SS faceplate survives institutional wash-downs; latch adjustable 0.5–20 sec.

STI · NT-SS001-EN

STI NoTouch® Stainless Steel Switch Slim/Mullion - NT-SS001-EN

• IP65-rated 304 stainless steel housing withstands splash and heavy-use environments.
• Form C dry contact relay integrates with any 12VDC/24VDC strike, mag-lock, or access panel.
• Adjustable 0.5–20 sec relay latch and 1.5–6 in. detection range simplify site-specific tuning.

STI · NT-SS002-EN

STI NoTouch® Stainless Steel Switch Slim/Mullion - NT-SS002-EN

• Form C dry contact (0.5A @ 120VAC / 1A @ 24VDC) ties directly into existing lock circuits.
• IP65-rated 304 stainless housing supports mullion retrofit without frame modification.
• Adjustable 0.5–20 s relay latch delay matches door-closer timing; IR range 1.5–6 inches.

STI · NT-SS002-FR

STI NoTouch® Stainless Steel Switch Slim/Mullion - NT-SS002-FR

• Infrared NoTouch activation eliminates contact, reducing cross-contamination in high-traffic areas.
• 12VDC operation integrates directly with existing strikes, maglocks, and access control panels.
• Slim mullion form factor with integrated back box retrofits standard door frames with minimal modification.

STI · NT-SS200-EN

STI NoTouch® Stainless Steel Switch, US Double-Gang, Door Symbol

Contactless stainless steel switch for access control and automatic doors

• NoTouch® infrared activation eliminates hand contact in high-traffic areas
• Stainless steel construction resists corrosion for indoor and semi-outdoor use
• 12VDC operation compatible with standard access control and door systems

STI · NT-SS100-EN

STI NoTouch® Stainless Steel Switch, US Single-Gang, Door Symbol

Hands-free stainless steel switch with door symbol for access control

• Contactless NoTouch® activation reduces surface contact in high-traffic areas
• 12VDC operation with IP65 rating for healthcare and secure entry points
• Stainless steel construction resists corrosion in demanding environments

STI · NT-SS101-EN

STI NT-SS101-EN NoTouch Stainless Steel Switch Single-Gang EXIT

Contactless stainless steel exit switch, 12VDC, IP65 rated

• NoTouch activation eliminates physical contact for high-traffic areas
• Stainless steel construction with IP65 rating for durability
• Single-gang US form factor integrates with standard access control systems

STI · NT-SS101-FR

STI NT-SS101-FR NoTouch Stainless Steel Switch Single-Gang EXIT

Stainless steel contactless EXIT switch for touchless access control

• 12VDC single-gang switch eliminates hand contact in high-traffic areas
• IP65-rated stainless steel construction resists moisture and hygiene risks
• IR motion sensing activates EXIT function without physical touch points

STI · NT-SS102-EN

STI NT-SS102-EN NoTouch® Stainless Steel Switch US Single-Gang

Hands-free stainless steel switch for access control, no touch required

• Contactless activation eliminates physical contact points in high-traffic areas
• Stainless steel construction rated IP65 for durability in wet environments
• 12VDC operation integrates with standard access control and door strike systems

STI · NT-SS201-EN

STI NT-SS201-EN NoTouch Stainless Steel Switch Double-Gang EXIT

Touchless stainless steel exit switch for hands-free access control

• Infrared sensor activation eliminates contact points in high-traffic areas
• Stainless steel housing resists corrosion in wet and humid environments
• 12VDC relay output with double-gang config fits standard electrical boxes

STI · NT-SS202-EN

STI NT-SS202-EN NoTouch Stainless Steel Switch Double-Gang

• IP65-rated 304 stainless steel faceplate withstands washdowns in healthcare and food-service zones.
• Form C dry contact (0.5A/120VAC, 1A/24VDC) integrates directly with mag locks and relay-driven strikes.
• Dual-gang IR detection at 1.5–6 in controls two independent circuits from one plate on 12VDC/45mA draw.

STI · STI-7533

STI Protective Cabinet - Polycarbonate with Backplate, Siren Alarm,...

NEMA 4X polycarbonate cabinet with integrated siren alarm for outdoor access control

• Impact-resistant polycarbonate withstands harsh outdoor, wet, and coastal environments
• Integrated siren alarm provides audible notification for access events and security alerts
• Lock/strike assembly with wall and pedestal mounting for flexible installation options

STI · STI-7525

STI Protective Cabinet with Siren/Strobe Alarm, Thumb Lock

NEMA 4X protective cabinet with thumb lock and siren/strobe alarm

• Thumb lock access control with integrated siren and strobe alarm system
• NEMA 4X steel construction rated for indoor and outdoor environments
• Wall-mounted design for secure storage of access control equipment

STI · STI-12006

STI STI-12006 Mugger Stopper Plus Electric Strike

• Operates at 9VDC for direct integration with low-voltage access control panels.
• Electric strike enables remote or credential-based door release without high-current draw.
• Suits retrofit and new installations using standard low-voltage wiring and strike circuits.

STI · STI-1250

STI STI-1250 Flush Mount Electric Strike with Fire Label

Fire-labeled flush mount strike, 9VDC, silent operation for access control

• Fits standard door frame cavities with no surface housing required
• 9VDC low-voltage operation simplifies control system integration
• Fire-labeled certification meets life-safety compliance on rated doors

STI · STI-1250NR

STI STI-1250NR Weather Stopper Flush Mount Electric Strike

• Runs on included 9V DC battery—no hardwired power needed for remote deployments.
• Closed-cell gaskets seal against rain and temps from -40°F to 250°F for outdoor use.
• UL-listed flush-mount fits standard frames; works with cards, keypads, and proximity readers.

STI · STI-1331

STI STI-1331 Universal Stopper® Electric Strike

Universal Stopper® electric strike for retrofit and new access control installations

• 9VDC operation integrates with standard access control relay systems and battery backup
• Universal Stopper® design fits multiple door frame types without custom modifications
• Wall-mount configuration supports both retrofit and new installation deployments

STI · STI-34752

STI STI-34752 Wireless Outdoor Motion Detector

• Wireless PIR operates at 12VDC, eliminating cable runs in outdoor perimeter zones.
• Achieves ~1,000 ft line-of-sight range, enabling flexible placement without conduit.
• Supports up to 34,752 event records for enterprise-scale multi-zone deployments.

STI · STI-6522-C

STI STI-6522-C Bopper Stopper Clear Biometric Keypad Reader

Fingerprint + keypad reader with clear housing and dual authentication

• Dual-mode authentication combining fingerprint recognition with keypad entry
• TCP/IP and RS-232 connectivity for integration into HID-based access control
• Clear polycarbonate housing allows visual inspection of status and components

STI · STI-6522-S

STI STI-6522-S Bopper Stopper Biometric Reader

Fingerprint + PIN dual-factor reader for access control door entry

• Fingerprint recognition with integrated keypad for two-factor authentication
• Standalone or multi-reader infrastructure compatible with door control systems
• IR low-light capability with mounting frame for direct installation

STI · STI-7504

STI STI-7504 Snooper Stopper Clear Keypad Reader

Clear keypad reader blocks shoulder surfing at door entry points

• Transparent housing lets users see keypad while preventing code observation
• Door-mounted design integrates with standard access control systems
• Compact 95mm × 75mm form factor fits most credential entry installations

STI · STI-7505

STI STI-7505 Snooper Stopper Keypad Reader Smoke

• Smoke tint blocks shoulder-surf PIN reads at high-traffic entry points.
• Mounts over existing keypad hardware—no reader replacement required.
• Secured with six #8×1 in. screws into 3/16 in. holes; gasket trims to fit.

STI · STI-7535

STI STI-7535 Protective Cabinet with Siren/Strobe Alarm Thumb

• UV-stabilised polycarbonate housing provides transparent visibility while blocking vandal access.
• Integrated 100dB siren/strobe alarm delivers immediate audible and visual tamper detection.
• Single 9V battery powers the standalone unit — no network or AC wiring required.

STI · STI-9620

STI STI-9620 Motion Detector Damage Stopper

Electronic strike assembly for access control door systems

• Gauge 9 steel wire with polyester coating resists corrosion in high-traffic areas.
• Corner-mount design installs tool-free, reducing service time in accessible locations.
• Wire frame absorbs impact without degrading PIR detector range or sensitivity.

STI · STI-9621

STI STI-9621 Motion Detector Damage Stopper Strike

Motion-integrated damage stopper strike for high-impact access control

• Integrated motion detection eliminates a separate sensor, cutting wiring runs and labor.
• Damage stopper strike geometry shields door frame hardware in high-impact environments.
• Wall and corner mount options support flexible deployment in retrofit or new installations.

STI · STI-9622

STI STI-9622 Motion Detector Damage Stopper

Motion detector strike for forced-entry protection on access doors

• Gauge-9 steel wire cage shields PIR detectors from impact without masking the lens.
• Corrosion-resistant polyester coating suits indoor industrial and light-duty environments.
• Tool-free removal keeps routine detector maintenance fast with no permanent alterations.

STI · STI-9703

STI STI-9703 Light Damage Stopper® Door Strike

• Operates on 12V or 24V DC, fitting directly into standard access control circuits.
• Fits door frames from 1-3/8" to 2-1/4", covering most commercial single-door deployments.
• Six-anchor mount installs with a standard 1/4" drill bit; hardware included.

STI · STI-6550

STI Widebody Keypad Protector without Lock - Clear - STI-6550

• Clear polycarbonate housing lets you inspect button condition and LEDs without removal.
• Rated −40°F to 250°F; UV-resistant molding handles harsh indoor and outdoor environments.
• Tool-free install with included anchors and screws; no wiring or frame modifications needed.

STI · STI-34759

STI Wireless Outdoor Motion Detector Alert with Single Channel Slav...

Wireless outdoor motion detector with wired power and remote alerts

• Single channel slave unit integrates into larger security systems
• Wired power supply with wireless alert transmission to master unit
• Rated for outdoor environments in residential and commercial perimeter applications

STI · STI-V34760

STI Wireless Outdoor Motion Detector Alert with Voice Receiver

Wireless outdoor PIR motion detector with voice alerts for perimeter security

• Wireless PIR detection eliminates cable runs for faster outdoor perimeter deployment.
• Supports up to 34,752 user assignments, scaling across multi-building campus installations.
• Voice receiver delivers audible zone alerts on 12VDC power for real-time operator notification.

System Sensor · CO-PLATE

System Sensor CO-PLATE CO Detector Replacement Plate

TCP/IP CO detector replacement plate for networked fire safety systems

• Replaces CO1224T, CO1224TR, and CO1224A faceplates without full device re-certification.
• Mounts to a standard single-gang back box and runs on the existing 24VDC supply.
• Maintains UL 2075 (US) and CSA 6.19-01 (Canada) compliance after plate swap.

System Sensor · D4240

System Sensor D4240 4-Wire Duct Smoke Detector 120VAC

4-wire duct smoke detector for supply/return air HVAC monitoring

• 4-wire supervised wiring supports alarm, trouble, and reset on conventional or addressable panels.
• Runs on 120VAC, eliminating the need for a separate low-voltage power supply in HVAC installations.
• Compact 14.38" x 5" x 2.5" housing fits standard supply or return air duct cutouts without modification.

Takex · KP-100

Takex KP-100 1m Steel Pole Kit (Pair)

Steel pole kit pair for 1m perimeter sensor mounting

• Two 1-meter steel poles included for paired transmitter and receiver
• 1m detection range pairing for close-proximity beam coverage zones
• Outdoor steel construction for ground-mount perimeter installations