i-PRO PGKV1215VAC1 Replacement Cover Dome
Overview
The i-PRO PGKV1215VAC1 is a replacement acrylic cover dome for fixed dome surveillance cameras in the i-PRO line. Deploy this when an existing dome shows lens scratching, optical haze from UV exposure, or cosmetic damage — you swap the cover without replacing the entire camera head or disturbing mounting and wiring. This mechanical accessory restores image clarity and weatherproofing without a full camera replacement. The acrylic construction maintains optical transmission while protecting the lens assembly from environmental stress.
Compatibility
The PGKV1215VAC1 is designed for i-PRO fixed dome camera models using the PGKV1215VAC form factor. Compatibility depends on mounting diameter and lens protrusion depth — form factors vary across the i-PRO product line. Verify your installed camera model against the i-PRO compatibility matrix before ordering. Check the model designation stamped on your existing camera housing or consult the datasheet for your specific camera. Mismatched form factors will not seal properly and will compromise environmental ratings and mechanical fit.
Installation Notes
The PGKV1215VAC1 requires removal of the existing dome and installation of the replacement in its place. You will need standard hand tools — typically a hex key or screwdriver — to remove and re-install fasteners. Power down the camera before starting the swap. Before assembly, clean gasket seals and weatherproofing surfaces to remove dirt or trapped debris; contamination degrades environmental protection and optical transmission. Torque specifications and detailed step-by-step procedures are in the i-PRO installation guide for your specific camera model.
