Camden

Camden

SKU: CM-1182

Camden CM-1182 Key Switch DPDT Momentary

• DPDT configuration controls two independent circuits from a single key activation.
• Momentary spring-return contact prevents sustained power draw on strikes or mag-locks.
• Die-cast aluminum housing withstands outdoor and high-humidity environments like loading docks.

Camden

SKU: CM-1180

Camden CM-1180 Key Switch DPDT Momentary

• DPDT momentary contacts switch two independent circuits simultaneously at 30VDC.
• Die-cast quarter-inch aluminum body withstands prying and weathering on commercial doors.
• Accepts 1", 1-1/8", or 1-1/4" mortise cylinders for straightforward retrofit installs.

Camden

SKU: CM-1170

Camden Key Switch SPDT (1) Momentary \& (1) Maintained - CM-1170

• Dual SPDT contacts (momentary + maintained) eliminate external relay hardware in retrofit installs.
• 30VDC operation integrates directly with standard low-voltage access control panels and power supplies.
• Accepts 1", 1-1/8", or 1-1/4" mortise cylinders for broad retrofit cylinder compatibility.

Camden

SKU: CM-1160

Camden CM-1160 Key Switch 2 SPDT Maintained

• Two independent SPDT maintained contacts hold 30VDC state without relay logic.
• Die-cast aluminum housing resists vandal and tamper attempts in high-traffic installs.
• Fits 1", 1-1/8", or 1-1/4" mortise cylinders for drop-in retrofit on legacy hardware.

Camden

SKU: CM-1130

Camden CM-1130 Key Switch SPDT Maintained Contact

SPDT key switch with maintained contacts for 30VDC strike control

• Dual NO/NC contacts stay actuated until manually reset—no relay logic needed
• 30VDC operation integrates directly with standard access control panels
• TCP/IP network support connects to HID reader systems without gateway device

Camden

SKU: CM-1105

Camden CM-1105 Key Switch SPST Momentary N/C

• SPST momentary N/C contact closes only while key is held, supporting fail-safe door circuits.
• Rated 30V DC, integrates directly with standard low-voltage strike and access control relays.
• Die-cast aluminum housing with tamperproof screws resists vandalism in high-traffic installations.

Camden

SKU: CM-1070

Camden Surface Mount Key Switch SPDT Momentary \& - CM-1070

• SPDT contacts support both momentary and maintained modes from a single switch.
• Rated 30V DC for direct integration with standard strike and EM lock circuits.
• Die-cast aluminum surface mount housing includes rubber gasket for indoor/outdoor use.

Camden

SKU: CM-1010

Camden CM-1010 Surface Mount Key Switch SPST Maintained

• Maintained SPST contact holds electric strikes and mag locks without manual reset.
• 30VDC rating directly drives strike coils and relay loads—no stepping relay needed.
• Surface-mount die-cast aluminum housing installs on existing frames without cutouts.

Camden

SKU: CM-1000/45

Camden SPDT maintained contact switch 6 A @ 125 V 3 - CM-1000/45

• SPDT maintained contacts hold state without coil power, eliminating idle heating.
• Dual rating (6A/125VAC, 3A/30VDC) covers both legacy DC strikes and 120VAC loads.
• TCP/IP interface enables remote status monitoring without dedicated hardwired relay racks.

Camden

SKU: CM-1000/42

Camden DPDT momentary contact switch 6 A @ 125 V 3 - CM-1000/42

• DPDT momentary closure prevents sustained strike energization, reducing life-safety risk.
• Dual rating (6A@125VAC / 3A@30VDC) works with AC strike and DC mag-lock supplies directly.
• Mortise cylinder mount (1"–1¼") enables key-controlled access without added hardware.

Camden

SKU: CM-1000/37

Camden SPST maintained contact switch heavy duty 15 - CM-1000/37

• Maintained 15A/30 VDC SPST contact holds closed after key turn—no continuous key pressure needed.
• 1/4" die-cast aluminum housing with rubber gasket supports indoor or outdoor wall and pole mounting.
• Pre-wired 18 AWG color-coded leads with heat-shrink sleeves enable direct relay or strike controller wiring.

Camden

SKU: CM-1000/35

Camden SPST maintained contact (on/off) switch 6 A - CM-1000/35

• Maintained SPST output latches on/off, eliminating relay chatter on strikes and door-holds.
• Rated 6A@125VAC, 3A@250VAC, and 30VDC—one switch spans low-voltage and line-voltage installations.
• Mortise cylinder interface fits 1", 1-1/8", or 1-1/4" cylinders with no set screws required.

Camden

SKU: CM-1000/32

Camden SPST momentary contact switch N/C 6 A @ 125 - CM-1000/32

• N/C contacts default closed, preserving locked state during power loss for failsafe designs.
• Dual-rated 6A@125VAC and 3A@30VDC supports both AC strikes and DC mag-locks on one SKU.
• TCP/IP integration connects directly to controller platforms without additional gateways.

Camden

SKU: CM-1000/31

Camden SPST momentary contact switch N/O heavy duty - CM-1000/31

• 15A at 30VDC SPST N/O rating handles electric strike and mag-lock loads directly.
• Accepts 1", 1-1/8", and 1-1/4" mortise cylinders with no modification required.
• Cast aluminum enclosure with weather gasket supports wall or pole outdoor deployment.

Camden

SKU: CM-1000/21

Camden Single gang neoprene gasket for Camden push - CM-1000/21

• Neoprene construction seals against moisture and dust in outdoor deployments.
• Direct single-gang drop-in replacement requires no hardware modification.
• Rated for 30VDC Camden push button assemblies, maintaining existing infrastructure.

Camden

SKU: CI-PBS3

Camden 3 button OPEN/CLOSE/STOP NEMA 1 3 A @ 250 VAC - CI-PBS3

• Three independent momentary contacts (OPEN/CLOSE/STOP) give direct mechanical gate control.
• Rated 3A @ 250VAC, compatible with any gate operator accepting momentary switch inputs.
• Stainless steel NEMA 1 enclosure suits indoor and protected industrial mounting locations.

Camden

SKU: CI-3BXL

Camden CI-3BXL Electronic Door Lock with Key Override

• Key lockout blocks manual entry when electronic access is active, preventing bypass.
• Accepts 12V or 24V supply, fitting directly into existing access control panel wiring.
• Fail-safe or fail-secure mode is field-selectable to match site egress requirements.

Camden

SKU: CX-MA0611

Camden Glass (1/2\" thick) Door Mounting Kit for 600 lb. Magnetic Lock

1/2" glass door mount for 600 lb magnetic lock strikes with TCP/IP

• 600 lb holding force magnetic strike for frameless glass installations
• 24VDC operation with TCP/IP integration into networked access control
• Purpose-built mounting hardware for 1/2" thick glass door applications

Camden

SKU: CX-92S-12TDS

Camden 1,200 lbs. Surface mount double door magnetic lock - with ad...

1,200 lbs surface-mount magnetic lock with TCP/IP network control

• 24VDC magnetic lock rated for 1,200 lbs door capacity on double doors
• TCP/IP communication integrates with networked access control systems
• Surface-mount installation on double door frames for institutional use

Camden

SKU: CV-550SPK

Camden CV-550SPK Standalone Proximity Reader & Keypad

Standalone proximity + keypad reader; 20,000 credentials, one relay output

• HID 125kHz proximity cards with integrated PIN keypad in one mounted device
• Stores 20,000 user credentials locally; no centralized panel required for single door
• OSDP and Wiegand support; 16VDC operation with one dry-contact relay for strike control