Camden

SKU: CM-5085RPTE

Camden Spring Return DPST 1-60 sec Pneumatic Time - CM-5085RPTE

• DPST contacts deliver simultaneous NO and NC switching from a single actuator at 24VDC/6A.
• Mechanical pneumatic timer adjusts 1–60 sec with no panel power required for timing cycles.
• Rated 1,000,000 activation cycles with auto spring-return—no manual reset in high-traffic egress.

Camden

SKU: CM-4085RPTE

Camden Spring Return DPST 1-60 sec Pneumatic Timer - CM-4085RPTE

• DPST configuration switches two independent circuits simultaneously from one activation.
• 1–60 sec adjustable pneumatic delay integrates directly into 24VDC access control rails.
• Spring-return mechanism fails safe to deactivated state on power or air interruption.

Camden

SKU: CM-7085

Camden Spring Return, DPST 1-60 SEC Pneumatic Time Delay, (Requires...

Adjustable pneumatic time delay 1-60 sec, DPST switch for access control

• 1–60 second adjustable delay with spring return pneumatic actuation at 24VDC
• DPST configuration integrates with HID credential and TCP/IP networked systems
• Pneumatic timing mechanism operates independent of electrical supply variations

Camden

SKU: CM-1000/35

Camden SPST maintained contact (on/off) switch 6 A - CM-1000/35

• Maintained SPST output latches on/off, eliminating relay chatter on strikes and door-holds.
• Rated 6A@125VAC, 3A@250VAC, and 30VDC—one switch spans low-voltage and line-voltage installations.
• Mortise cylinder interface fits 1", 1-1/8", or 1-1/4" cylinders with no set screws required.

Camden

SKU: CM-1000/37

Camden SPST maintained contact switch heavy duty 15 - CM-1000/37

• Maintained 15A/30 VDC SPST contact holds closed after key turn—no continuous key pressure needed.
• 1/4" die-cast aluminum housing with rubber gasket supports indoor or outdoor wall and pole mounting.
• Pre-wired 18 AWG color-coded leads with heat-shrink sleeves enable direct relay or strike controller wiring.

Camden

SKU: CM-1000/32

Camden SPST momentary contact switch N/C 6 A @ 125 - CM-1000/32

• N/C contacts default closed, preserving locked state during power loss for failsafe designs.
• Dual-rated 6A@125VAC and 3A@30VDC supports both AC strikes and DC mag-locks on one SKU.
• TCP/IP integration connects directly to controller platforms without additional gateways.

Camden

SKU: CM-1000/30

Camden SPST momentary contact switch N/O 6 A @ 125 - CM-1000/30

• Dual-rated 6A@125VAC / 3A@30VDC covers line- and low-voltage circuits natively.
• Accepts 1"–1¼" mortise cylinders with rotation-locking locators; no set screws needed.
• Die-cast aluminum housing with rubber gasket supports outdoor wall or pole mounting.

Camden

SKU: CM-1000/31

Camden SPST momentary contact switch N/O heavy duty - CM-1000/31

• 15A at 30VDC SPST N/O rating handles electric strike and mag-lock loads directly.
• Accepts 1", 1-1/8", and 1-1/4" mortise cylinders with no modification required.
• Cast aluminum enclosure with weather gasket supports wall or pole outdoor deployment.

Camden

SKU: CM-PT375SS-18

Camden Stainless steel endcaps 18\" length - CM-PT375SS-18

• 304/316-grade stainless steel resists corrosion in coastal and high-humidity installs.
• 18-inch rigid profile covers standard door-frame conduit runs without sag or gaps.
• Sized for 3/8-inch ID power transfer cable; verify cable diameter before ordering.

Camden

SKU: CM-PT250SS-7

Camden Stainless steel endcaps, 7\" length (Formerly CM-PTSS-7)

7" stainless steel endcap assembly with TCP/IP and RS-232 support

• Corrosion-resistant stainless steel construction for durable deployments
• Dual communication: TCP/IP for networked systems and RS-232 for serial
• 7-inch length sized for standard access control enclosure integration

Camden

SKU: CM-PT375SS-7

Camden Stainless steel endcaps, 7\" length (Formerly CM-PTSS38-7)

7" stainless steel endcaps for corrosion-resistant Camden access control

• Corrosion-resistant stainless steel construction rated for outdoor environments
• 7-inch length compatible with Camden access control door systems
• TCP/IP and RS-232 communication support for integrated security deployments

Camden

SKU: CX-EPD-2000L

Camden Standard body No faceplate - CX-EPD-2000L

• 24VDC operation integrates directly with Camden CX-PS10UL and CX-PS30UL supplies.
• Faceplate-free design supports OEM builds and retrofit installations with existing panels.
• Standard body housing provides a clean base for custom access control configurations.

Camden

SKU: CM-23D

Camden Surface Box Deep - For wireless. - CM-23D

• Deep surface-mount profile installs without wall cavity prep—ideal for retrofits.
• TCP/IP communication integrates directly into networked access control platforms.
• Wireless-reader compatibility eliminates hardwired credential line runs per door.

Camden

SKU: CM-34D

Camden Surface Box Extra Deep - For wireless. Heavy - CM-34D

• Extra-deep cavity fits full-sized wireless reader modules and EM strike coils.
• Surface-mounts directly to door frames—no wall recess or conduit chase required.
• Rated 30VDC and outdoor-rated polymer construction handles exterior deployments.

Camden

SKU: CM-75SB

Camden Surface Box for CM-7536 16-gauge steel Powder - CM-75SB

• 16-gauge powder-coated steel resists corrosion and impact in outdoor covered installs.
• Surface-mount design eliminates cavity cutting, reducing retrofit labor on existing frames.
• Native TCP/IP over Ethernet integrates with Genetec, Milestone, and Tyco platforms.

Camden

SKU: CM-75SB-BK

Camden Surface Box for CM-7536 Black 16-gauge steel - CM-75SB-BK

• 16-gauge black steel body withstands mechanical impact, UV, and moisture at outdoor sites.
• Purpose-built for CM-7536 only; houses dual 15A Form-C contacts for two-door wiring.
• Shallow 10.62″×5.88″×1.50″ profile mounts flat on columns, frames, or wall studs.