Camden

SKU: CM-AF142SO

Camden Single Gang Multi-Color LED Dome Light w/ - CM-AF142SO

• Combines 93 dB piezo sounder and multi-color LED into one single-gang unit.
• Accepts 12V or 24V AC/DC, integrating with virtually any access control panel.
• Color selection (red/green/blue) set at wiring time — no controller software needed.

Camden

SKU: CM-420RPTE

Camden Single gang N/O and N/C contacts Red button - CM-420RPTE

• Dual N/O and N/C contacts enable strike activation and alarm supervision in one device.
• Accepts 12V or 24V DC, compatible with standard access control power supplies and solenoids.
• Single-gang ABS housing retrofits directly into existing electrical boxes with no adapters.

Camden

SKU: CM-1000/21

Camden Single gang neoprene gasket for Camden push - CM-1000/21

• Neoprene construction seals against moisture and dust in outdoor deployments.
• Direct single-gang drop-in replacement requires no hardware modification.
• Rated for 30VDC Camden push button assemblies, maintaining existing infrastructure.

Camden

SKU: CM-450RL-7724-CPC

Camden Single gang Push/Pull N/O \& N/C - CM-450RL-7724-CPC

• Dual N/O and N/C contact blocks fire from one press, eliminating external relay stages.
• 6A @ 30V rating drives EM strikes and solenoid locks on 12–24V AC/DC without amplification.
• Free-spinning 18-gauge stainless button resists jamming and abuse in high-traffic corridors.

Camden

SKU: CM-450R

Camden Single gang Push/Pull N/O \& N/C Stainless - CM-450R

• Dual N/O and N/C contacts fire simultaneously, eliminating external relay logic.
• 18-gauge stainless steel construction meets NEMA 4X rating for washdown and salt-air.
• Free-spinning vandal-resistant button installs in any standard single-gang wall box.

Camden

SKU: CV-110SPK

Camden Slim-line stand alone prox. reader \& keypad - CV-110SPK

• Dual-protocol output (OSDP + Wiegand) integrates with modern and legacy panels.
• Reads HID 37-bit and AWID 34-bit prox formats; supports up to 2,000 users.
• Standalone design consolidates reader and keypad into one device for single-door installs.

Camden

SKU: CM-1000/45

Camden SPDT maintained contact switch 6 A @ 125 V 3 - CM-1000/45

• SPDT maintained contacts hold state without coil power, eliminating idle heating.
• Dual rating (6A/125VAC, 3A/30VDC) covers both legacy DC strikes and 120VAC loads.
• TCP/IP interface enables remote status monitoring without dedicated hardwired relay racks.

Camden

SKU: CM-1000/40

Camden SPDT momentary contact switch, 6 A @ 125 VAC, 3 A @ 30 VDC

SPDT momentary switch for door strikes and locks, TCP/IP networked

• 6 A @ 125 VAC / 3 A @ 30 VDC rated for solenoid strikes and relays
• TCP/IP enabled integration with networked access control systems
• SPDT momentary contact operation for electronic lock and strike control

Camden

SKU: CM-5085GPTE

Camden Spring Return DPST 1-60 sec Pneumatic Time - CM-5085GPTE

• Field-adjustable 1–60 sec pneumatic delay eliminates separate electrical timers.
• DPST contacts at 24VDC/6A drive magnetic strikes or solenoids without added relays.
• Mechanical spring return resets on power loss, preventing stuck contacts at egress doors.

Camden

SKU: CM-5085RPTE

Camden Spring Return DPST 1-60 sec Pneumatic Time - CM-5085RPTE

• DPST contacts deliver simultaneous NO and NC switching from a single actuator at 24VDC/6A.
• Mechanical pneumatic timer adjusts 1–60 sec with no panel power required for timing cycles.
• Rated 1,000,000 activation cycles with auto spring-return—no manual reset in high-traffic egress.

Camden

SKU: CM-4085RPTE

Camden Spring Return DPST 1-60 sec Pneumatic Timer - CM-4085RPTE

• DPST configuration switches two independent circuits simultaneously from one activation.
• 1–60 sec adjustable pneumatic delay integrates directly into 24VDC access control rails.
• Spring-return mechanism fails safe to deactivated state on power or air interruption.

Camden

SKU: CM-7085

Camden Spring Return, DPST 1-60 SEC Pneumatic Time Delay, (Requires...

Adjustable pneumatic time delay 1-60 sec, DPST switch for access control

• 1–60 second adjustable delay with spring return pneumatic actuation at 24VDC
• DPST configuration integrates with HID credential and TCP/IP networked systems
• Pneumatic timing mechanism operates independent of electrical supply variations

Camden

SKU: CM-1000/35

Camden SPST maintained contact (on/off) switch 6 A - CM-1000/35

• Maintained SPST output latches on/off, eliminating relay chatter on strikes and door-holds.
• Rated 6A@125VAC, 3A@250VAC, and 30VDC—one switch spans low-voltage and line-voltage installations.
• Mortise cylinder interface fits 1", 1-1/8", or 1-1/4" cylinders with no set screws required.

Camden

SKU: CM-1000/37

Camden SPST maintained contact switch heavy duty 15 - CM-1000/37

• Maintained 15A/30 VDC SPST contact holds closed after key turn—no continuous key pressure needed.
• 1/4" die-cast aluminum housing with rubber gasket supports indoor or outdoor wall and pole mounting.
• Pre-wired 18 AWG color-coded leads with heat-shrink sleeves enable direct relay or strike controller wiring.

Camden

SKU: CM-1000/32

Camden SPST momentary contact switch N/C 6 A @ 125 - CM-1000/32

• N/C contacts default closed, preserving locked state during power loss for failsafe designs.
• Dual-rated 6A@125VAC and 3A@30VDC supports both AC strikes and DC mag-locks on one SKU.
• TCP/IP integration connects directly to controller platforms without additional gateways.

Camden

SKU: CM-1000/30

Camden SPST momentary contact switch N/O 6 A @ 125 - CM-1000/30

• Dual-rated 6A@125VAC / 3A@30VDC covers line- and low-voltage circuits natively.
• Accepts 1"–1¼" mortise cylinders with rotation-locking locators; no set screws needed.
• Die-cast aluminum housing with rubber gasket supports outdoor wall or pole mounting.