Vivotek GEL-065A-060 vs Comelit 10081: Specification Comparison
Both the Vivotek AW-GEL-065A-060 and the Comelit 10081 are 6-port PoE switches targeting physical-security installations — IP cameras, access control readers, and intercoms. The Vivotek is a Lite Managed switch with Layer 2 feature depth, while the Comelit is an unmanaged (or minimally managed) PoE switch marketed for VIP intercom and IP camera ecosystems. Buyers evaluating either unit are typically specifying a small-site edge switch where PoE budget, port count, and management capability are the primary decision axes.
In This Guide
- Which switch delivers more PoE power and how is that budget distributed across ports?
- What Layer 2 management and network resilience features does each switch offer?
- How do the two switches compare on physical environment ratings, form factor, and ecosystem compatibility?
- Which should you choose: the GEL-065A-060 or the 10081?
- Side-by-Side Specs
- FAQ
Which switch delivers more PoE power and how is that budget distributed across ports?
The Vivotek AW-GEL-065A-060 provides 4 PoE-capable Gigabit ports rated at 30W each (IEEE 802.3af/at compliant), with a total PoE power budget of 60W. Two additional GE RJ45 ports serve as uplinks and carry no PoE. Per-port surge protection is rated at 4KV on every PoE port, and the unit supports Extend PoE Mode (up to 250 m) as well as Non-Stop PoE to maintain power to attached devices during switch reboots.
The Comelit 10081 specifies IEEE 802.3af only, with a per-port maximum of 15.4W — the 802.3af ceiling. Total PoE budget and the number of PoE-capable ports among the 6 are not stated in the supplied specification data. No surge protection rating, extend-range mode, or non-stop PoE feature is documented for the 10081.
For deployments with 802.3at (25.5W) devices such as pan-tilt cameras, multi-sensor units, or IEEE 802.3at-class access-control panels, the Vivotek's 30W-per-port 802.3at support is a hard requirement. The Comelit 10081 is limited to 802.3af loads (≤15.4W), suited to fixed 2MP cameras, single-door controllers, and Comelit intercom stations within that power envelope.
What Layer 2 management and network resilience features does each switch offer?
The Vivotek AW-GEL-065A-060 is a Lite Managed switch with a documented feature set: 802.1Q tag-based VLAN (4096 IDs), port-based VLAN, IEEE 802.1d STP, IEEE 802.1w RSTP, Link Aggregation Control Protocol (LACP), CoS port-based / 802.1p / DSCP QoS, loop protection, flow control, storm control, port-based mirroring, port isolation, bandwidth control, static MAC table (4K entries), and PoE-specific controls including per-port on/off, auto-checking, and non-stop PoE. Switching bandwidth is 12 Gbps with a 1 MB buffer and 9216-byte jumbo frame support.
The Comelit 10081 lists 'Software 6' under management and 'ONVIF: Yes' under VMS compatibility. No VLAN, STP/RSTP, QoS, LACP, loop protection, mirroring, or storm control capabilities are specified in the provided data. Switching bandwidth, buffer size, MAC table capacity, and jumbo frame support are not documented.
For installations requiring traffic segmentation (cameras on a dedicated VLAN isolated from corporate LAN), resilience against loops, or QoS prioritization of video streams, the Vivotek's managed feature set directly addresses those needs. The Comelit 10081's ONVIF notation indicates compatibility with ONVIF-compliant cameras and VMS platforms, but its network management capabilities cannot be confirmed beyond 'Software 6' from the available specification data.
How do the two switches compare on physical environment ratings, form factor, and ecosystem compatibility?
The Vivotek AW-GEL-065A-060 specifies an operating temperature of 0°C to 50°C (32°F to 122°F), storage temperature of -20°C to 70°C, and operating humidity of 10–90% RH. Dimensions are 200 × 118 × 44 mm at 0.66 kg. AC input is 100–240V / 50–60 Hz with a maximum draw of 65W. Regulatory marks listed are CE, FCC, LVD, and VCCI. Included accessories are a power cord, quick installation guide, and rack-mount kit. Warranty is 24 months.
The Comelit 10081 carries a 2-year warranty and lists a form factor of 'Network Switch' compatible with 19-inch rack mounting. Operating temperature, humidity range, input voltage, power consumption, and physical dimensions are not provided in the specification data supplied. The unit is noted as compatible with IP cameras and access control systems and carries ONVIF VMS compatibility. Regulatory certifications are not listed in the provided data.
The Vivotek unit ships with a rack-mount kit and has fully documented environmental tolerances, which matters for integrators writing specifications or qualifying hardware for a particular enclosure or climate. The Comelit 10081's fit for 19-inch racks and access cabinets is noted in marketing copy, but the absence of temperature, power, and dimension specs in the provided data prevents a direct environmental comparison.
Which should you choose: the GEL-065A-060 or the 10081?
Our take: The AW-GEL-065A-060 is the stronger choice when the installation requires 802.3at-class PoE loads, Layer 2 management, or documented environmental ratings. Concretely: the Vivotek delivers 30W per PoE port versus the Comelit's 15.4W ceiling, supports a confirmed 60W total PoE budget versus an unspecified budget for the 10081, and provides a full managed feature set — 4096-ID VLAN, RSTP, LACP, per-port QoS, storm control, and 4KV surge protection — none of which are documented for the Comelit. The Comelit 10081 may suit narrow Comelit VIP intercom deployments where ONVIF compatibility and 802.3af-only loads are sufficient and the total PoE budget is acceptable, but critical specifications (total PoE budget, temperature range, switching bandwidth) are absent from the provided data, making a complete evaluation impossible without the manufacturer's full datasheet.
Side-by-Side Comparison
Spec-for-spec, from manufacturer data.
| Specification | Vivotek GEL-065A-060 | Comelit 10081 |
|---|---|---|
| Total Ports | 6 | 6 |
| PoE Ports | 4 | Not specified |
| Uplink / Non-PoE Ports | 2 × GE RJ45 | Not specified |
| PoE Standard | IEEE 802.3af / 802.3at | IEEE 802.3af only |
| Max PoE Per Port | 30W | 15.4W |
| Total PoE Budget | 60W | — |
| Switching Bandwidth | 12 Gbps | — |
| MAC Address Table | 4K | — |
| Jumbo Frames | 9216 Bytes | — |
| VLAN Support | 802.1Q (4096 IDs) + Port-based | — |
| STP / RSTP | 802.1d / 802.1w | — |
| QoS | Port / 802.1p / DSCP | — |
| Loop Protection | Yes | — |
| PoE Surge Protection | 4KV per PoE port | — |
| Extend PoE Mode | Yes (250 m) | — |
| ONVIF Compatibility | — | Yes |
| Operating Temperature | 0°C to 50°C | — |
| Dimensions (W × D × H) | 200 × 118 × 44 mm | — |
| Weight | 0.66 kg | — |
| AC Input | 100–240V / 50–60 Hz | — |
| Max Power Draw | 65W | — |
| Warranty | 24 months | 2 years |
| Regulatory | CE, FCC, LVD, VCCI | — |
Frequently Asked Questions
Which should you choose: the GEL-065A-060 or the 10081?
The AW-GEL-065A-060 is the stronger choice when the installation requires 802.3at-class PoE loads, Layer 2 management, or documented environmental ratings. Concretely: the Vivotek delivers 30W per PoE port versus the Comelit's 15.4W ceiling, supports a confirmed 60W total PoE budget versus an unspecified budget for the 10081, and provides a full managed feature set — 4096-ID VLAN, RSTP, LACP, per-port QoS, storm control, and 4KV surge protection — none of which are documented for the Comelit. The Comelit 10081 may suit narrow Comelit VIP intercom deployments where ONVIF compatibility and 802.3af-only loads are sufficient and the total PoE budget is acceptable, but critical specifications (total PoE budget, temperature range, switching bandwidth) are absent from the provided data, making a complete evaluation impossible without the manufacturer's full datasheet.
Is the AW-GEL-065A-060 or the 10081 better for powering PTZ or multi-sensor cameras?
The AW-GEL-065A-060 is the appropriate choice. It supports IEEE 802.3at with up to 30W per PoE port, which covers most PTZ and multi-sensor cameras that exceed the 15.4W 802.3af limit. The Comelit 10081 is rated for 802.3af only (15.4W per port maximum), so it cannot power devices that require 802.3at without an external mid-span injector.
Can I put cameras and access control on separate VLANs with either of these switches?
Yes, with the Vivotek AW-GEL-065A-060: it supports 802.1Q tag-based VLAN with up to 4096 VLAN IDs and port-based VLAN. VLAN capability is not documented in the specification data provided for the Comelit 10081, so that function cannot be confirmed for that unit without consulting Comelit's full datasheet.
Which switch is a better fit for a Comelit VIP intercom system?
The Comelit 10081 is explicitly marketed for Comelit VIP intercom and IP camera ecosystems and carries an ONVIF compatibility notation. Comelit intercom stations typically operate within 802.3af power limits (≤15.4W), so the 10081's power class aligns with that ecosystem. The Vivotek AW-GEL-065A-060 will also power 802.3af Comelit devices, and its managed features add network segmentation capability, but it is a general-purpose surveillance switch rather than a Comelit-specific product.
More Network Switch Comparisons
- Vivotek GEL-065A-060 vs Comelit 1440
- Vivotek GEL-065A-060 vs Comelit 1440A
- Comelit 10081 vs Code Blue SLNP0018
- Comelit 10081 vs Comelit 1440
- Comelit 10081 vs Comelit 1440A
- Code Blue SLNP0018 vs Comelit 1440
Network Switch Buying Guides
Get a Second Opinion on Your Camera Choice
Share your site layout, coverage goals, and budget. Our team will validate the camera selection, flag anything we would change, and recommend products that match the use case.