STI

STI

SKU: KIT-AP2100-W

STI White Notched Replacement Shell for Stopper® - KIT-AP2100-W

• Direct mechanical swap maintains original mounting footprint and TCP/IP interfaces.
• 9VDC power requirement unchanged—no controller or network reconfiguration needed.
• White notched shell replaces damaged Stopper® Station housings without touching strike logic.

STI

SKU: KIT-AP2100-GZA

STI Green Notched Replacement Shell for - KIT-AP2100-GZA

• Direct replacement shell restores Stopper Station function without full assembly swap.
• Engineered for HID credential readers on 9VDC circuits — no rewiring required.
• Notched geometry and four-point mounting ensure precise mechanical alignment on reinstall.

STI

SKU: KIT-7520-HTR

STI Replacement Heater Plate for STI-7520-HTR and - KIT-7520-HTR

• Replaces heater element in STI-7520-HTR and STI-7521-HTR strikes without full assembly swap.
• Operates at 9V DC, matching existing strike circuit power — no voltage conversion needed.
• Sealed plate geometry eliminates thermal dead zones that cause inconsistent latch engagement.

STI

SKU: KIT-7500-HTR

STI Replacement Heater for STI-7510 and STI-7511 series

Direct replacement heater for STI-7510 and STI-7511 locks

• 9VDC wired heating element for temperature-sensitive access control
• Integrates with TCP/IP and RS-232 control systems
• Wall-mount design for straightforward installation and replacement

STI

SKU: KIT-320

STI Replacement Wiring Harness for the Universal - KIT-320

• Rated 9V DC to match Universal Stopper series power specs, preventing intermittent lock cycles.
• TCP/IP-ready design integrates strike status and commands into network-based access control platforms.
• Purpose-built for Universal Stopper series, enabling harness swaps without full hardware replacement.

STI

SKU: KIT-318

STI KIT-318 Adapter Plate

• Eliminates custom fabrication by providing a standardized mounting interface for electronic strikes.
• Operates at 9VDC, aligning with standard strike circuit power provisioning in access control systems.
• Simplifies multi-door deployments by standardizing strike installation across varied frame geometries.

STI

SKU: KIT-314

STI KIT-314 Adapter Plate for HID Credentials

HID adapter plate for STI lock/strike hardware integration

• Integrates HID credential readers with existing STI assemblies
• Operates at 9VDC for standard access control power supply
• Wall-mount adapter plate eliminates controller redesign needs

STI

SKU: KIT-18015-RC

STI Replacement Cable for STI-6200 STI-6205 and - KIT-18015-RC

• Direct replacement cable restores power continuity in STI-6200, STI-6205, and STI-6210 strikes.
• Rated 9VDC — matches native supply voltage of the STI-6200 series without reconfiguration.
• Drop-in fit eliminates access control system reprogramming after harness failure or damage.

STI

SKU: KIT-18015-9

STI Deactivation cable (6 in.) for STI-6200, STI-6205 or STI-6210

6-inch deactivation cable for STI strike and lock systems

• Works with STI-6200, STI-6205, and STI-6210 electronic strikes
• Operates at 9VDC with RS-485 and RS-232 serial communication
• Compact 6-inch length for tight door frame installations

STI

SKU: KIT-10EM

STI Replacement glass for STI-4100EM & STI-4130EM - - KIT-10EM

• Drop-in fit for STI-4100EM and STI-4130EM eliminates reader replacement or rewiring.
• Matches 9VDC operating voltage of parent devices; no power supply changes required.
• Includes weather gasket and cable entry gaskets to maintain environmental protection.

STI

SKU: KIT-10-FR

STI KIT-10-FR Replacement Glass for STI-4100-FR

Replacement glass for STI-4100-FR 10-door access control system

• Supports up to 10 doors with 9VDC wired power and RS-232 communication
• Direct compatibility with STI-4100-FR lock and strike hardware
• Maintenance replacement component for multi-door facility deployments

STI

SKU: KIT-08

STI Replacement Break-Glass Tool for Break Glass - KIT-08

• Drop-in replacement for Stopper II and Weather Stopper II frames; no new drilling required.
• Operates at 9VDC, matching existing Stopper series power architecture for seamless integration.
• Restores break-glass capability on installed housings without requiring full unit replacement.

STI

SKU: KIT-06297F

STI KIT-06297F Lock/Strike Accessory Kit - F Spacer

F Spacer kit for HID lock/strike systems at 9VDC

• F-series spacer corrects gap alignment between strike plate and door frame at install.
• Designed for HID credential environments; operates at 9VDC for low-voltage door hardware.
• Includes wall fixings, anchors, and cable entry inserts for clean surface-mount deployment.

STI

SKU: G3A429LD-EN

STI G3 Multipurpose Push Button Flush Mount with - G3A429LD-EN

• Flush-mount housing reduces snag risk in high-traffic door entries.
• NC/NO/COM terminals support both fail-safe and fail-secure strike wiring.
• Integrated 12VDC audio output requires no separate power supply or module.

STI

SKU: G3A349PO-EN

STI G3 Multipurpose Push Button, Flush Mount with Sound, No Camera,...

12VDC flush-mount push button with audio feedback for access control

• Dual relay outputs (NO/NC/COM) integrate with standard strike control systems
• Integrated sound output confirms button activation to users
• Recessed mount fits standard electrical boxes in entry installations

STI

SKU: ES2316BR

STI Fiberglass Enclosure, Lock, Cable Pass-Through Brush Seal

Fiberglass enclosure with lock and brush seal for outdoor access control

• Fiberglass construction withstands outdoor exposure without corrosion or warping.
• Integrated lock secures access control readers and credential hardware from tampering.
• Brush seal pass-through manages cabling entry while maintaining environmental protection.

STI

SKU: EPSPBKT

STI EPSPBKT EnviroArmour Swing Panel Mount Brackets

• Mounts 9VDC electric strikes to swing door frame panels without jamb mortising.
• Solves constrained-jamb retrofit installs where surface-panel mounting is required.
• Pairs with compatible DC-powered electric strikes to complete the strike assembly.

STI

SKU: EM243608A1

STI Metal Protective Cabinet with AC/Heater - - EM243608A1

• UL Type 4 rated metal enclosure guards electronics from dust, moisture, and vandalism.
• Integrated AC and heater maintains safe operating temps in harsh or exposed environments.
• Protects internal equipment up to 21″ L × 33″ H × 6″ D with horizontal wall mount.

STI

SKU: EFSPBKT

STI EFSPBKT EnviroArmour Swing Panel Bracket Kit

Door frame bracket kit for STI swing panels, 9VDC access control

• Steel construction with environmental protection for secure panel mounting
• Designed for STI swing panel assemblies in access control installations
• Operates on 9VDC standard compatible with access control power supplies

STI

SKU: EFAPBKT

STI EFAPBKT EnviroArmour Fiberglass Stationary Panel Bracket Kit

Fiberglass bracket kit for access control panel mounting and weather protection

• Fiberglass construction withstands outdoor exposure on stationary panel installations
• Includes bracket assembly and mounting hardware for wall-mount door strike systems
• 9VDC operation integrates with standard access control and reader configurations