Camden

Camden

SKU: CM-2050

Camden CM-2050 Key Switch with Dual SPDT Momentary

• Dual independent SPDT circuits enable simultaneous control of two separate door devices.
• Momentary-only action prevents continuous lock bypass — circuit closes only while key is held.
• Operates at 30VDC, integrating directly with standard 24–30V mag locks and electric strikes.

Camden

SKU: CM-2010

Camden CM-2010 Key Switch SPST Maintained

• SPST maintained contact holds circuit state at 30VDC without repeated actuation.
• Die-cast 1/4-inch aluminum body resists tampering and corrosion at outdoor entries.
• Mortise cylinder fits 1", 1-1/8", or 1-1/4" bores for master-key system integration.

Camden

SKU: CM-120wV2

Camden Outdoor vandal resistant metal backlit keypad - CM-120wV2

• Vandal-resistant metal housing and backlit keypad sustain outdoor exposure reliably.
• Wiegand output integrates directly with standard access control panels and door strikes.
• Supports up to 999 users and accepts HID credentials on 24VDC power.

Camden

SKU: CM-120TX

Camden Outdoor vandal resistant metal backlit keypad - CM-120TX

• Battery-operated 915 MHz wireless eliminates conduit runs in outdoor deployments.
• Supports 999 unique PIN codes with 1–8 digit variable-length entries per user.
• Stainless steel vandal-resistant faceplate installs flush in a standard single-gang box.

Camden

SKU: CM-120i

Camden Stand alone or Wiegand flush mount 999 users - CM-120i

• Standalone or Wiegand flush-mount keypad stores 999 user PINs
• 12/24V AC/DC operation drops into standard access power buses
• Variable-length PIN code support for tiered access policies

Camden

SKU: CM-1082

Camden CM-1082 Surface Mount Key Switch DPDT Momentary

• Dual DPDT momentary contacts rated 30VDC enable direct strike or EM lock control.
• Accepts any standard 1"–1¼" mortise cylinder, including master-key and restricted keyways.
• ¼" die-cast aluminum housing with rubber gasket supports indoor and outdoor surface mount.

Camden

SKU: CM-1080

Camden CM-1080 Surface Mount Key Switch DPDT Momentary

• DPDT momentary contacts let you drive two independent circuits—strike plus shunt—from one key turn.
• 30VDC rating integrates directly with standard access control power supplies; no voltage conversion needed.
• Accepts 1", 1-1/8", or 1-1/4" mortise cylinders in a die-cast aluminum surface-mount housing.

Camden

SKU: CM-1060

Camden Surface Mount Key Switch (2) SPDT Maintained - CM-1060

• Dual SPDT maintained contacts hold lock state without continuous power cycling.
• Accepts standard 1"–1¼" mortise cylinders—no drilling or custom adapters needed.
• Die-cast aluminum housing with rubber gasket mounts directly to standard junction boxes.

Camden

SKU: CM-1050

Camden CM-1050 Surface Mount Key Switch SPDT Momentary

• Dual SPDT momentary contacts rated 30VDC reset to neutral on key release—no latch logic needed.
• Die-cast 1/4-inch aluminum body with rubber gasket supports indoor and outdoor surface mounting.
• Accepts standard 1–1¼-inch mortise cylinders, fitting common commercial keying systems.

Camden

SKU: CM-1030

Camden Surface Mount Key Switch SPDT N/O \& N/C - CM-1030

• SPDT maintained contacts provide simultaneous N/O and N/C circuits on one switch.
• 30VDC rating aligns with standard access control panel voltages for direct integration.
• 1/4-inch die-cast aluminum housing supports surface mount in demanding door applications.

Camden

SKU: CM-1000/30

Camden SPST momentary contact switch N/O 6 A @ 125 - CM-1000/30

• Dual-rated 6A@125VAC / 3A@30VDC covers line- and low-voltage circuits natively.
• Accepts 1"–1¼" mortise cylinders with rotation-locking locators; no set screws needed.
• Die-cast aluminum housing with rubber gasket supports outdoor wall or pole mounting.

Camden

SKU: 60-36D003-V2

Camden For 1,200 lbs. Magnetic Locks, V1, (open pin connector)

1,200 lbs magnetic lock controller with open pin connector for access systems