Geovision TBL4710-0010 vs Geovision TBL480W-0010: Specification Comparison
Both the Geovision TBL4710-0010 and TBL480W-0010 are 4MP fixed bullet cameras from Geovision's IP camera line, sharing H.265 compression, WDR Pro, and IR night vision. A buyer evaluating either for perimeter or entry-point coverage would reasonably cross-shop these two models. The comparison below is drawn strictly from the provided specifications; where a spec is absent for one model, that absence is noted explicitly.
In This Guide
How do the imaging specs compare?
Both cameras deliver 4MP resolution with H.265 compression and WDR Pro, making them equivalent on sensor resolution and wide-dynamic-range capability as stated in the provided specs. Neither spec sheet supplies lens focal length, minimum illumination figure, maximum frame rate, or image sensor size, so those parameters cannot be compared here.
On IR night vision, the TBL480W-0010 specifies an 850nm IR wavelength, giving installers a concrete wavelength value for scene-planning in total darkness. The TBL4710-0010 lists IR night vision but does not specify wavelength or IR range distance in the provided specs. Neither model's IR throw distance is given, so range comparison is not possible from the available data.
What about installation and environment?
The TBL480W-0010 explicitly lists PoE as both its connectivity and power method, simplifying single-cable installation and eliminating a separate power run. The TBL4710-0010 does not specify PoE or any power input method in the provided specs, so whether it supports PoE cannot be confirmed. Installers should verify power requirements with the TBL4710-0010 datasheet before designing the circuit.
Mount-type coverage differs slightly: the TBL4710-0010 supports Wall and Pole mounting; the TBL480W-0010 supports Wall and Ceiling mounting. Neither model's IP rating, IK impact rating, operating temperature range, or enclosure dimensions are present in the provided specs, so environmental suitability for outdoor or vandal-prone locations cannot be compared from this data alone.
Which fits your VMS and analytics better?
The TBL480W-0010 carries explicit ONVIF Profile S compliance and is listed as compatible with Geovision software and third-party NVR platforms, giving integrators a defined interoperability baseline. The TBL4710-0010 lists compatibility with Geovision software and 'ONVIF-compatible VMS' but does not specify a named ONVIF profile, which may matter for strict profile-gated integrations.
Neither model lists edge analytics, onboard audio, or SD card / edge storage capability in the provided specifications. The TBL4710-0010 carries cable category 'MPCam' while the TBL480W-0010 is catalogued as 'IPCAM'; buyers should confirm with Geovision whether MPCam designates a proprietary cabling or encoding scheme that affects third-party VMS compatibility.
Which should you choose: the TBL4710-0010 or the TBL480W-0010?
Our take: The TBL480W-0010 is the stronger choice when single-cable PoE deployment and verified ONVIF Profile S compliance are requirements. It explicitly confirms PoE power, 850nm IR wavelength, and ONVIF Profile S—three installation and integration data points the TBL4710-0010 does not provide in the available specs. The TBL4710-0010's MPCam cable category designation is unresolved and could introduce third-party VMS friction that the TBL480W-0010 avoids. On the other hand, the TBL4710-0010 supports Pole mounting, which the TBL480W-0010 does not list, making it the documented choice for pole-top or streetlight-arm deployments. Both cameras match on 4MP resolution, WDR Pro, H.265, and IR night vision. Where specs are absent for both—IP rating, temperature range, IR distance, lens, and frame rate—neither model has a demonstrable advantage from the data provided.
Side-by-Side Comparison
Spec-for-spec, from manufacturer data.
| Specification | Geovision TBL4710-0010 | Geovision TBL480W-0010 |
|---|---|---|
| Resolution | 4 MP | 4 MP |
| Camera Type | Bullet | Bullet |
| Video Compression | H.265 | H.265 |
| WDR | WDR Pro | WDR Pro |
| Night Vision / IR | IR | IR (850nm) |
| IR Wavelength | — | 850nm |
| Power Input / PoE | — | PoE |
| Connectivity | — | PoE |
| ONVIF | ONVIF-compatible VMS (profile not specified) | ONVIF Profile S |
| VMS Compatibility | Geovision software; ONVIF-compatible VMS | ONVIF Profile S; Geovision; Third-party NVR platforms |
| Mount Type | Wall; Pole | Wall; Ceiling |
| Cable Category | MPCam | IPCAM |
Frequently Asked Questions
Which should you choose: the TBL4710-0010 or the TBL480W-0010?
The TBL480W-0010 is the stronger choice when single-cable PoE deployment and verified ONVIF Profile S compliance are requirements. It explicitly confirms PoE power, 850nm IR wavelength, and ONVIF Profile S—three installation and integration data points the TBL4710-0010 does not provide in the available specs. The TBL4710-0010's MPCam cable category designation is unresolved and could introduce third-party VMS friction that the TBL480W-0010 avoids. On the other hand, the TBL4710-0010 supports Pole mounting, which the TBL480W-0010 does not list, making it the documented choice for pole-top or streetlight-arm deployments. Both cameras match on 4MP resolution, WDR Pro, H.265, and IR night vision. Where specs are absent for both—IP rating, temperature range, IR distance, lens, and frame rate—neither model has a demonstrable advantage from the data provided.
Is the TBL4710-0010 or TBL480W-0010 better for low-light performance?
Based on the provided specs, the TBL480W-0010 has a slight documentation advantage: it specifies 850nm IR wavelength, giving you a concrete parameter for night-vision scene planning. The TBL4710-0010 lists IR night vision but does not specify wavelength or IR range. Neither model's minimum illumination figure or IR throw distance is provided, so a full low-light comparison cannot be made from the available data.
Can I power both cameras over PoE from a standard PoE switch?
The TBL480W-0010 explicitly lists PoE as its power and connectivity method, so it is designed for standard PoE switch deployment. The TBL4710-0010 does not specify PoE or any power input in the provided specs. Confirm the TBL4710-0010's power requirements with Geovision's datasheet before assuming PoE compatibility.
Which camera works with non-Geovision NVR platforms?
The TBL480W-0010 explicitly states ONVIF Profile S compliance, which is the industry-standard interoperability baseline for third-party NVR platforms. The TBL4710-0010 lists 'ONVIF-compatible VMS' without naming a specific profile, which may be sufficient for many platforms but cannot be confirmed to the same level of specificity from the provided specs. For strict profile-gated integrations, the TBL480W-0010 is the better-documented choice.
Get a Second Opinion on Your Camera Choice
Share your site layout, coverage goals, and budget. Our team will validate the camera selection, flag anything we would change, and recommend products that match the use case.