Potter

Potter

SKU: BUA-1000

Potter BUA-1000 Dual Channel Backup Amplifier

Dual-channel backup amp for emergency audio systems with redundancy

• Dual independent channels support multi-zone deployment or single-source redundancy.
• Backup amplification path maintains audio continuity during primary system failures.
• Rack-mount form factor integrates directly into standard emergency communication racks.

Potter

SKU: AFC-1000V

Potter AFC1000V Integrated Voice Panel

Integrated voice panel for multi-door access control coordination

• Consolidates voice communication and access control logic into one panel, reducing infrastructure.
• Supports proximity, smart card, and keypad readers for flexible multi-door credential deployments.
• Wall, ceiling, pendant, and rack mount options simplify installation across varied site layouts.

Potter

SKU: AE-14

Potter AE-14 14 Card Expansion Enclosure

14-slot expansion enclosure for modular Potter security systems

• Holds up to 14 expansion cards in one 19" rack-mount enclosure, consolidating capacity.
• Rack-mount form factor (19" × 27 3/8" × 4 5/8") fits standard commercial panel installations.
• Modular card slots let technicians add or replace modules without full system replacement.

Potter

SKU: 70V-1000

Potter 70V-1000 Extender

70V audio extender for extended speaker runs without signal loss

• Extends 70V speaker runs without signal degradation or impedance mismatch.
• Rack-mount form factor simplifies installation in standard equipment enclosures.
• Supports paging, emergency notification, and multi-zone background audio deployments.

Potter

SKU: PSN-1000E

Potter PSN-1000 Series Intelligent Notification Power Expander

Rack-mount notification expander for Potter access control systems

• Rack-mount form factor (26" × 17.6" × 3.75") fits standard 19" cabinet deployments.
• Offloads notification circuits from the primary controller, reducing electrical stress on core hardware.
• Supports 18 AH battery capacity with ANSI Temporal Code 3 and City Tie output options.

Potter

SKU: PSB-10

Potter PSB-10 Bulk Power Supply

Regulated 24/12VDC supply for multi-door access and surveillance

• Delivers regulated 24VDC at 10A sustained to power multi-door strikes and readers.
• Switch-mode design cuts thermal output and power draw versus linear supplies on 24/7 loads.
• Supervised battery charging (27.3VDC @ 1A) with dual 5A trouble relays for panel supervision.

Potter

SKU: PAD300-DUCT

Potter PAD300-DUCT Duct-Mounted Smoke Detector

Photoelectric duct smoke detector for supply/return air plenums

• Photoelectric sensing catches smoldering fires in duct airstreams before smoke spreads.
• Integrates with conventional supervised alarm loops for broad panel compatibility.
• Compact 13.5" x 4.5" x 2.25" form factor fits standard commercial ductwork installations.

Potter

SKU: FMT

Potter Electric Fire Systems Facility Management Software

Centralized fire system management across multiple locations with real-time alerts

• Single-pane dashboard monitors fire detection zones across multiple distributed locations.
• Role-based access control separates operator, technician, and admin permissions natively.
• Timestamped event logs support compliance documentation and operator action auditing.

Potter

SKU: AE-2

Potter AE-2 Accessory Expansion Enclosure

Modular expansion enclosure for Potter multi-door access systems

• Adds up to 2 stacker-bracket expansion cards without replacing the main control board.
• UUKL Listed, satisfying code requirements for smoke control and fire-rated environments.
• Compact 9¾" × 8" × 2½" steel enclosure mounts flush to wall or cabinet via #8 screws.

Potter

SKU: PAM-4

Potter PAM-4 Polarized Relay Module

Polarized relay module for access control and door strike switching

• Polarized coil rejects reverse-polarity wiring, eliminating silent mis-connection faults.
• Supports 12VDC and 24VDC control circuits for flexible panel integration.
• Isolates load circuits from control panels, protecting main relay capacity across door zones.

Potter

SKU: MIZ-24S-W

Potter MIZ-24S-W Wireless Access Control Module

Wireless access control module for retrofit and new construction

• Eliminates cable runs between readers and controllers, cutting installation labor.
• Integrates natively into Potter access control—no gateway or protocol translation needed.
• Wall-mount form factor in white finish suits indoor retrofits without enclosure mods.

Potter

SKU: MC-1000

Potter MC-1000 Multi-Connect Expander Module

Modular expander adds reader and door capacity to Potter access systems

• Adds reader and door capacity to Potter access systems without replacing the primary controller.
• Supports proximity, smart card, and biometric readers within a single expander module.
• Mounts in panel, accessory cabinet, or PSN-1000/E Power Supply; rated 0°C–49°C.

Potter

SKU: AE-8

Potter AE-8 8 Card Expansion Enclosure

8-slot expansion enclosure for Potter access control systems

• Adds 8 card slots to Potter access control systems without full panel replacement.
• Rack-mount form factor (16" × 17" × 3") fits standard equipment room installations.
• Hot-swappable card architecture minimizes downtime during upgrades or maintenance.

Potter

SKU: SB-24

Potter SB-24 Switchboard

Dual-voltage switchboard for multi-door access control signal routing

• Accepts 12V or 24V DC power, fitting existing panel infrastructure without conversion.
• Rack-mount form factor installs cleanly in standard security cabinets and enclosures.
• Up to four SB-24 units stack per IPA-4000V, scaling capacity without replacing hardware.

Potter

SKU: PAD300-PCD

Potter PAD300-PCD

Multi-door access controller with modular expansion for mid-to-large installations

• Modular multi-door architecture scales with phased mid-to-large installations.
• Network-ready design supports centralized or distributed deployment without vendor lock-in.
• UUKL Listed for Smoke Control; backed by a 5-year manufacturer warranty.

Potter

SKU: PAD300-DUCTR

Potter PAD300-DUCTR

Networked multi-door access control with encrypted credential support

• Wiegand-compatible inputs support HID, Salto, Nedap, and other major reader platforms.
• Ethernet-networked architecture enables remote credential provisioning and access management.
• Encrypted credential transmission secures authentication data across all connected entry points.

Potter

SKU: LOC-1000

Potter LOC-1000 Local Operator Console

Local operator console for standalone access control without network dependency

• Operates standalone without network dependency, keeping access control live during outages.
• Real-time door and access point status monitoring simplifies multi-reader deployments.
• Built-in microphone support enables audio interaction directly at the operator console.

Potter

SKU: AFC-1000E

Potter AFC-1000E

Multi-zone fire alarm panel with conventional and addressable detector support

• Supports both conventional and addressable detector networks for retrofit or new builds.
• Field-programmable zone configuration enables custom alarm verification and notification routing.
• AC/DC power inputs with battery backup ensure continuous operation during outages; NFPA 72 compliant.

Potter

SKU: PSK-1000

Potter PSK-1000

Electric door strike kit for multi-door access control systems

Potter

SKU: PAD300-SB

Potter PAD300-SB

Hardwired 4-door panel with 10,000-credential capacity for enterprise access control