Ubiquiti NANOHD-RETROFIT-3 Mounting Hardware

Ubiquiti NANOHD-RETROFIT-3 nanoHD Retrofit Mount

Overview

The NANOHD-RETROFIT-3 is a polycarbonate retrofit mount designed specifically for Ubiquiti nanoHD access points. At 187.8mm diameter and 16.7mm profile, it solves the problem of retrofitting compact APs into existing ceiling cavities and architectural spaces where standard external pole mounts won't fit. Weighing just 105g, it imposes minimal structural load while keeping the AP securely positioned during installation and operation. Use this when you're integrating nanoHD units into suspended ceilings, recessed plenums, or flush-mount architectural voids.

Compatibility

Designed specifically for Ubiquiti UniFi nanoHD access points. Verify your exact nanoHD model against the UniFi product family before ordering — this mount is engineered for the nanoHD form factor and will not work with other UniFi AP series (such as U6, U7, or larger models). The mount integrates with UniFi management ecosystems without requiring additional configuration or firmware updates.

Installation Notes

The compact 187.8mm diameter fits standard suspended ceiling grid openings and architectural cavities. Polycarbonate construction is lightweight but rigid enough to support the nanoHD AP during commissioning and service access. Plan for adequate cable access in the cavity space — ensure power (PoE) and network cabling can route cleanly to the recessed position without kinks or stress on connectors. If the cavity is tight or has thermal concerns, verify airflow around the mounted AP to avoid thermal throttling during sustained high traffic.