DMP 718T Plug-In Screw Terminal Module
The DMP 718T is a plug-in screw terminal accessory designed to simplify field wiring integration in DMP modular control system deployments. This terminal module connects directly into DMP expansion slots, providing standardized wire connection points that reduce installation complexity and support faster system commissioning across security system architectures.
Key Features
- Screw Terminal Design: Eliminates the need for soldering or proprietary connectors—wires attach directly via captive screws. This means faster field termination, easier troubleshooting, and reduced risk of cold solder joints during installation.
- Plug-In Compatibility: The 718T integrates into standard DMP expansion module slots, supporting modular reconfiguration without chassis redesign. You can add or swap terminals as system I/O requirements change.
- Tool-Free Operation: Connections and disconnections do not require specialized tools beyond a standard screwdriver—a real advantage during maintenance windows or when swapping field wiring for diagnostics.
- Modular Expansion Support: Designed for use with DMP control platforms, the 718T enables integrators to scale I/O capacity without replacing the entire control system.
- Certified Installation: Suitable for deployment by qualified security integrators and installation technicians familiar with modular control system workflows and field wiring practices.
Integration & Compatibility
The 718T module is compatible with DMP modular expansion platforms that support standard module insertion workflows. Verify your control system documentation to confirm available expansion slots before ordering. The terminal accepts field wiring from sensors, switches, and relay outputs typical in access control, intrusion detection, and fire system integrations.
Installation involves inserting the 718T into an available DMP expansion slot and then terminating field conductors to the screw terminals. No firmware updates or special configuration is required—the terminal operates as a passive I/O interface once installed and wired.
Frequently Asked Questions
Q: Is the DMP 718T compatible with all DMP control platforms?
A: The 718T is designed for DMP modular expansion systems. Confirm your specific control model supports plug-in terminal modules by consulting your system documentation or contacting your integrator.
Q: Can I mix the DMP 718T with other DMP expansion modules in the same system?
A: Yes. The 718T occupies a standard expansion slot and coexists with other compatible DMP modules, provided your control platform has sufficient available slots.
Q: What wire gauge does the 718T screw terminal accept?
A: Refer to the DMP 718T datasheet or your system documentation for specific wire gauge and current rating specifications. Oversized conductors or incorrect termination can damage the terminal.
Q: Do I need any special tools to install the DMP 718T?
A: A standard screwdriver is all that is required for terminal installation and wire termination. No soldering tools or crimpers are needed.
Ted PerryPerspective based on aggregated IP Security Depot and affiliated engineering team experience.
The DMP 718T fills a practical gap in modular control system deployment—it standardizes field termination without forcing integrators to stock multiple proprietary connector types. If your DMP platform supports expansion modules, the 718T eliminates one common pain point: managing dozens of loose wires or pre-terminated harnesses in the field. The screw terminal design is not novel, but it is reliable and serviceable.
Deployment Considerations:
- Expansion Slot Verification: Confirm your DMP control platform has available module slots before purchase. Not all DMP models support the same expansion architecture.
- Wire Termination Discipline: Screw terminals are only as good as the technician who wires them. Loose or incorrectly sized conductors will cause intermittent faults or signal loss. Train installation crews on proper torque and conductor preparation.
- Modular Scalability: Because the 718T plugs into standard slots, you can add terminals incrementally as system I/O grows—no need to swap control boards or expand enclosures.
The 718T is the right choice for integrators building DMP systems that require flexible field-wiring integration without proprietary adapters. It is most valuable in installations where I/O may change over time or where multiple technicians will handle maintenance and troubleshooting. Skip this if your DMP platform uses fixed hardwired connectors or if you prefer pre-assembled harness assemblies.
