ACTi PMAX-0804 Gang Box Converter
The PMAX-0804 is a mounting adapter that lets a compact ACTi dome or box camera install directly onto an existing two-gang electrical box instead of requiring a new surface-mount base. If a job site already has two-gang boxes roughed in from a prior camera, intercom, or keypad, PMAX-0804 lets you reuse that rough-in and cabling path rather than patching drywall or stucco for a new mounting footprint.
Compatibility
PMAX-0804 is built for ACTi camera models sized for a gang-box mount footprint and finished in matching white housing. It passes a PoE (802.3af) connection through the converter body, so it fits deployments where the camera itself draws power and data over a single Cat5e/Cat6 run terminated at the box. Confirm your specific ACTi camera model lists gang-box mounting compatibility before ordering, since not every ACTi dome or bullet series uses this mount pattern.
Installation Notes
The converter mounts to a standard two-gang electrical box, so no additional back-box or anchors are needed if the gang box is already set. It carries an outdoor environmental rating, so it holds up on exterior soffits, walls, and canopies exposed to weather — a relevant detail since gang boxes are common at building perimeters and loading dock entries where conduit runs already terminate. At 0.65 lb and roughly 6.6 x 6.9 x 0.7 inches, it adds minimal bulk behind the camera, keeping the finished mount low-profile against the wall or ceiling surface. White housing matches typical ACTi camera finishes for a clean sightline instead of a mismatched adapter color.
PMAX-0804 carries a 3-Year Warranty, consistent with ACTi's standard coverage on mounting hardware.
