Geovision GV-POE0410 4-Port PoE+ Switch

Geovision GV-POE0410 4-Port PoE+ Switch

Overview

The Geovision GV-POE0410 is a 4-port PoE+ switch engineered to consolidate power and data delivery for IP surveillance cameras, access control readers, and network devices in constrained cabinet or closet environments. It solves the common installation problem of running separate power lines to each device by delivering IEEE 802.3at PoE+ over standard Cat5e/Cat6 cabling. Each of the four RJ45 ports independently supports PoE+ power levels, allowing you to deploy multiple powered endpoints from a single upstream connection without dedicated AC runs to each location—a meaningful cost reduction when installing or retrofitting multi-camera sites.

Compatibility

The GV-POE0410 works with any IP device rated for PoE+ input conforming to IEEE 802.3at, including Geovision IP cameras, third-party surveillance equipment, PoE+ encoders, wireless access points, and VoIP endpoints. If you are deploying Geovision cameras or integrating them into broader surveillance architectures with mixed vendors, confirm the target device's PoE+ power budget (typically 25.5W maximum per port on 802.3at) against the switch's port capacity. The switch is plug-and-play for unmanaged operation; no configuration required to pass data and power simultaneously.

Installation Notes

The GV-POE0410 is designed for rack mount or network closet deployment. Ensure adequate airflow around the unit during installation—passive cooling is typical for compact PoE switches, so avoid enclosed spaces without ventilation. Use standard Cat5e or Cat6 cabling to connect powered devices; longer runs (up to approximately 100 meters for PoE+ compliance per IEEE standards) are supported, though power delivery diminishes slightly at maximum distances. No special tools or torque specifications are required for RJ45 connections—hand-tight termination is standard practice.