ACTi Z47 vs i-PRO X15700-V2L: Specification Comparison
Both the ACTi Z47 and i-PRO WV-X15700-V2L are 8MP fixed outdoor bullet cameras intended for perimeter and area surveillance applications. This comparison examines how they differ across imaging performance, environmental ratings, power requirements, and platform integration—factors that matter most to installers selecting hardware for long-term deployments. The two units share a resolution class and form factor, but diverge significantly in lens range, analytics depth, PoE class, and certification breadth.
In This Guide
How do the imaging specs compare?
The ACTi Z47 outputs 8MP at 30 fps and uses a motorized varifocal lens spanning 2.8–12mm, providing a 4.3× optical zoom range that allows remote reframing across a wide coverage envelope. It supports WDR and Adaptive IR with Day/Night switching. Minimum illumination figures are not stated in the provided specifications. The i-PRO WV-X15700-V2L also delivers 8MP (3840×2160) at 30 fps but uses a narrower 4.3–8.6mm motorized varifocal lens with only 2.0× optical zoom; however, it pairs this with a large-format 1/1.8-type CMOS sensor and a fast F1.5 maximum aperture, yielding a specified minimum illumination of 0.03 lux in monochrome mode. Its Super Dynamic WDR reaches up to 132 dB at maximum setting, a figure the Z47 spec sheet does not quantify.
For IR performance, the Z47's range is not numerically specified in the provided data, while the X15700-V2L lists 70m at 30IRE and 50m at 50IRE—concrete, measurable values useful for site design. The X15700-V2L also includes a built-in gyro-based image stabilizer (active at 30 fps only), fog compensation, and DORI-standard detection/observation/recognition/identification distances ranging from 6m to 154m depending on zoom and task. None of these metrics are present in the Z47 specifications.
What about installation and environment?
Both cameras carry IP67 and IK10 ratings, confirming resistance to full water immersion at 1m and to 20-joule impacts. The X15700-V2L adds IP66 and full NEMA 4X / Type 4X (UL50E) certifications, which are required for certain industrial and utility installations. The X15700-V2L also specifies wind resistance up to 40 m/s (approximately 89 mph), a figure absent from the Z47 data sheet. Operating temperature for the Z47 spans -40°C to 60°C; the X15700-V2L covers -40°C to 55°C, though it requires above -30°C for power-on, a cold-start constraint not mentioned for the Z47.
On power, the Z47 runs on standard 802.3af PoE at a maximum of 12.95W—compatible with any 802.3af switch port without upgrade. The X15700-V2L requires PoE+ (802.3at, Class 4) at up to 14W, meaning existing 802.3af-only infrastructure will need switch-port or midspan upgrades. The Z47 supports wall, pole, and ceiling bracket mounting; the X15700-V2L supports ceiling and wall mounting with specified pan (±180°), tilt (0–100°), and yaw (±190°/±145°) adjustment ranges. The X15700-V2L lists physical dimensions (133×133×383mm, 2.5kg); Z47 dimensions and weight are not provided in the supplied specifications.
Which fits your VMS and analytics better?
The Z47 supports ONVIF Profile S and Profile T. The X15700-V2L supports ONVIF Profiles G, S, T, and M—Profile G adds on-camera recording event management, and Profile M covers metadata including analytics. Both cameras include audio input; the X15700-V2L additionally specifies a 3.5mm audio output jack and supports G.726, G.711, and AAC-LC compression with half/full duplex modes. Edge storage on the X15700-V2L accepts microSD/SDHC/SDXC cards up to 512GB; the Z47 specification does not mention onboard storage capability.
Analytics depth is a decisive differentiator. The Z47 lists no edge analytics beyond ONVIF compliance in its provided specifications. The X15700-V2L includes an Ambarella CV52 SoC and specifies AI Video Analytics with face, people, and vehicle detection; AI sound classification covering gunshot, yell, vehicle horn, and glass break; VMD across four areas; scene change detection; and up to eight privacy zones in six colors. The X15700-V2L also carries UL 62368-1, c-UL, CE, and IEC 62368-1 safety certifications and FCC/ICES/CE EMC marks, and lists a 5-year warranty. No warranty term is stated for the Z47.
Which should you choose: the Z47 or the X15700-V2L?
Our take: The X15700-V2L is the stronger choice when low-light sensitivity, long IR range, deep AI analytics, and broad regulatory certification are the primary selection criteria. Its 1/1.8-type sensor with F1.5 aperture achieves 0.03 lux minimum illumination and a quantified 132 dB Super Dynamic WDR range—neither metric is available for the Z47. IR range is specified at 70m versus no stated figure for the Z47. The X15700-V2L's AI SoC adds sound classification and face/vehicle detection that the Z47 does not list. Conversely, the Z47's 2.8–12mm lens (4.3× zoom versus 2.0×) covers a wider focal range, operates on standard 802.3af PoE without infrastructure changes, and reaches 60°C versus 55°C maximum ambient. Choose the Z47 where lens flexibility and af-only switch compatibility are constraints; choose the X15700-V2L where low-light performance, certified analytics, NEMA 4X compliance, and ONVIF Profile G edge recording are required.
Side-by-Side Comparison
Spec-for-spec, from manufacturer data.
| Specification | ACTi Z47 | i-PRO X15700-V2L |
|---|---|---|
| Resolution | 8MP (not specified as pixel count) | 8MP / 3840×2160 |
| Image Sensor | Not specified | Approx. 1/1.8-type CMOS |
| Lens / Focal Length | 2.8–12mm motorized varifocal (4.3× zoom) | 4.3–8.6mm motorized varifocal (2.0× optical zoom) |
| Minimum Illumination | Not specified | 0.03 lux (B&W, 50IRE, F1.5, 1/30s) |
| IR Range | Not specified | 70m @ 30IRE; 50m @ 50IRE |
| WDR | WDR (range not quantified) | Super Dynamic up to 132 dB |
| Max Frame Rate | 30 fps @ 1440p | 30 fps @ 3840×2160 |
| Video Compression | H.265, H.264 | H.265, H.264, MJPEG |
| IP Rating | IP67 | IP66 / IP67 / NEMA 4X / Type 4X (UL50E) |
| IK / Impact Rating | IK10 | IK10 |
| Operating Temperature | -40°C to 60°C | -40°C to 55°C (-30°C power-on minimum) |
| Power Input / PoE Class | 802.3af PoE, 12.95W max | 802.3at PoE+ Class 4, 14W |
| ONVIF Profiles | Profile S, Profile T | Profile G, S, T, M |
| Edge Storage | Not specified | microSD/SDHC/SDXC up to 512GB |
| Audio | Audio input | Audio input (3.5mm) + Audio output (3.5mm), G.726/G.711/AAC-LC |
| AI / Edge Analytics | Not specified | AI face, people, vehicle detection; AI sound classification (gunshot, yell, horn, glass break) |
| Warranty | Not specified | 5-Year Warranty |
Frequently Asked Questions
Which should you choose: the Z47 or the X15700-V2L?
The X15700-V2L is the stronger choice when low-light sensitivity, long IR range, deep AI analytics, and broad regulatory certification are the primary selection criteria. Its 1/1.8-type sensor with F1.5 aperture achieves 0.03 lux minimum illumination and a quantified 132 dB Super Dynamic WDR range—neither metric is available for the Z47. IR range is specified at 70m versus no stated figure for the Z47. The X15700-V2L's AI SoC adds sound classification and face/vehicle detection that the Z47 does not list. Conversely, the Z47's 2.8–12mm lens (4.3× zoom versus 2.0×) covers a wider focal range, operates on standard 802.3af PoE without infrastructure changes, and reaches 60°C versus 55°C maximum ambient. Choose the Z47 where lens flexibility and af-only switch compatibility are constraints; choose the X15700-V2L where low-light performance, certified analytics, NEMA 4X compliance, and ONVIF Profile G edge recording are required.
Is the Z47 or X15700-V2L better for low-light performance?
Based on provided specifications, the X15700-V2L is the better-documented choice for low light. It lists a minimum illumination of 0.03 lux in monochrome mode, an F1.5 maximum aperture, and 70m IR range at 30IRE. The Z47 does not include minimum illumination or IR range figures in its supplied specifications, so a direct numerical comparison cannot be made.
Can I use my existing 802.3af PoE switches with both cameras?
The Z47 operates on 802.3af PoE at up to 12.95W and is compatible with any standard af switch port. The X15700-V2L requires PoE+ (802.3at, Class 4) at up to 14W, so 802.3af-only switch ports cannot power it without a PoE+ midspan injector or switch upgrade.
Which camera supports on-board edge storage for local recording?
The X15700-V2L supports microSD, SDHC, and SDXC cards up to 512GB for on-camera recording and also supports ONVIF Profile G for standardized edge recording management. The Z47 specification does not mention onboard storage capability.
Get a Second Opinion on Your Camera Choice
Share your site layout, coverage goals, and budget. Our team will validate the camera selection, flag anything we would change, and recommend products that match the use case.