Comnet CNFE1002MAC1A-M 100Mbps Media Converter

Overview

The Comnet CNFE1002MAC1A-M is a small-form-factor 100Mbps media converter designed to bridge copper Ethernet networks to fiber optic runs. This is the right device when your surveillance backbone uses single-mode or multimode fiber but your camera head-ends or edge switches are copper-based—the converter sits between them and handles the conversion transparently. AC/DC dual-input power means it works in cabinet-mounted or remote field installations without hunting for a specific power source.

Compatibility

The CNFE1002MAC1A-M accepts a standard ST fiber connector on the optical side and an RJ-45 Ethernet port on the copper side. It is compatible with any ONVIF-compliant IP camera or network video recorder that can push traffic over Ethernet to a media converter—no special driver or integration required. Typical deployments pair it with existing surveillance fiber backbone installations, remote camera sites fed by fiber runs, or any mixed fiber/copper network topology where you need a transparent bridge without IP-level management overhead.

Installation Notes

Mounting: the compact chassis (4.50 inches long, 10.30 inches wide, 2.50 inches tall) fits standard 19-inch rack ears or wall mounts in small form factor. Power: accepts either AC or DC input via terminal block—verify your local supply voltage before installation. Fiber: hand-tighten the ST connector; do not over-torque. Ethernet: standard RJ-45 connector with CAT6 or CAT5e cable recommended for full 100Mbps throughput. Allow 2–3 minutes warm-up time before traffic load testing to ensure optical alignment stabilizes.