QNAP TVR-AI200-16CH-16P-US 16-Channel PoE+ Smart NVR

Overview

The TVR-AI200-16CH-16P-US is a network video recorder purpose-built for small-to-mid commercial surveillance deployments where you need to power and record up to 16 IP cameras from a single 1U box without a separate PoE switch. All 16 PoE+ ports are onboard, so cameras wire directly to the unit — no intermediate switching layer, no extra power budget to plan. Maximum recording throughput is 160 Mbps at up to H.264 1920×1080/30fps per channel, and hardware-accelerated transcoding means the CPU is not the bottleneck when you're streaming live to a monitor while simultaneously writing to disk. Two 3.5-inch SATA 6Gb/s bays accept standard surveillance HDDs (drives are not included — size and count to your retention requirements). The 4GB system memory is fixed; no expansion path is documented. The single HDMI 1.4b output supports local monitor display up to 4096×2160 at 30Hz, useful for a lobby monitor or security desk without a separate decoder. For deployments requiring additional storage capacity or a higher channel count, the broader QNAP NVR lineup offers models that scale beyond this unit's two-bay ceiling.

Compatibility

The TVR-AI200-16CH-16P-US is designed for ONVIF-compatible IP cameras. The integrated PoE+ ports (802.3at) will power cameras drawing up to approximately 30W per port — standard for most dome, bullet, and turret IP cameras. Pair with PoE network switches upstream if you need to segment camera VLANs. Local display connects to any HDMI monitor; the 4096×2160 ceiling means a 4K monitor will display at full resolution. USB 2.0 (×2) and USB 3.2 Gen 1 (×1) ports support external storage for backup or export. This unit is US-region specific (TVR-AI200-16CH-16P-US) — confirm region compatibility before ordering international. For camera selection guidance, review the IP camera selection guide to match camera specs to PoE+ budget and channel requirements.

Installation Notes

The 1U rackmount form factor fits a standard 19-inch rack. The system ships without hard drives — install SATA surveillance-grade HDDs before commissioning. Flash memory is 4GB with dual-boot OS protection, so the OS partition does not consume drive bay space. Route PoE+ camera cabling to the rear panel; 16 ports in a 1U chassis means cable management planning is worthwhile before rack installation.