Vertiv VRA6035 Networking Roof Panel 800 x 1100

Overview

The VRA6035 is a networking roof panel sized 800mm wide by 1100mm deep, designed to close out the top of Vertiv VR open-frame racks where cable egress management and basic overhead protection are required. Instead of leaving the rack top open — which invites cable clutter and dust ingress from overhead — this panel provides a structured cap with cutouts suited for network cable pass-through. It is the 800mm-wide variant in a four-panel matrix; the 600mm-wide equivalent is the VRA6033, and the 1200mm-depth variants are the VRA6036 (800x1200) and VRA6034 (600x1200). Deploy it on Vertiv VR rack accessories where overhead cable routing to patch panels or top-of-rack switches needs a clean, enclosed transition.

Compatibility

The VRA6035 is part of the Vertiv VR open-frame rack accessory ecosystem. It is dimensionally matched to VR racks with an 800mm width and 1100mm depth footprint. Within the same family, pair it with the VRA6018 solid top panel (800x1100) if you need a fully sealed overhead versus a networking-specific cutout panel. Compatible rack bases in this depth include the VRA3010 (800x1100) and VRA3006 depth extension (42U x 800 x 200). Side panel options for these racks include VRA6009 (42U x 1100 split side panels) and VRA6011 (48U x 1100). Confirm your rack's width and depth before ordering — the 600mm-wide and 1200mm-deep variants are separate SKUs and are not interchangeable.

Installation Notes

Fit this panel after side panels and rails are seated, as the roof panel typically drops into the top frame last. Verify rack depth is 1100mm — installing on a 1200mm-depth frame will leave a gap. For cable pass-through bundling after installation, the VRA6021 top panel grommets are a direct companion accessory that seal around cables to reduce dust ingress once routes are finalized.