Vertiv VRA6034 Networking Roof Panel 600 x 1200

Overview

The VRA6034 is a networking roof panel sized 600mm wide by 1200mm deep, designed to close the top of Vertiv VR open-frame rack enclosures in that footprint. It provides a structured cable egress surface at the top of the rack — keeping horizontal cable runs organized as they transition off the frame into overhead trays or conduit. Where a standard solid top panel (VRA6019, same 600x1200 footprint) blanks the roof entirely, the VRA6034 is specifically configured for networking deployments that require active cable management or pass-through at the top of the cabinet.

Compatibility

Designed for Vertiv VR-series open-frame racks with a 600mm width and 1200mm depth profile. Within the VR accessory family, the 600x1200 footprint aligns with rack bases VRA3011 (VR 100x600x1200) and VRA3012 (VR 100x800x1200 — note: 800mm-wide racks use VRA6035 or VRA6036 roof panels instead). Pair with VRA6010 or VRA6012 split side panels for a fully enclosed 1200mm-deep cabinet, and VRA6021 top panel grommets if you need grommetted cable entries alongside the networking roof. For an 1100mm-depth rack, the equivalent networking roof panel is VRA6033 (600mm wide) or VRA6035 (800mm wide, 1100mm deep). Do not install on 800mm-wide rack frames — those require VRA6035 or VRA6036.

Installation Notes

Installs onto the top frame of compatible VR-series racks. Confirm your rack's width (600mm) and depth (1200mm) before ordering — the networking roof panel family spans four SKUs across two widths and two depths, and dimensional mismatches are the most common install error. If your deployment routes structured cabling overhead, coordinate the VRA6034 cutout orientation with your cable tray layout before mounting side panels, as access becomes restricted once the enclosure is fully assembled.