NETGEAR SC101TNA Network Attached Storage RAID Adapter
Overview
The SC101TNA is a single-bay network attached storage adapter designed for small deployments where you need consolidated backup or archive capacity without a full rackmount solution. This form factor bridges the gap between direct-attached storage and larger NAS arrays—it connects via Fast Ethernet (100 Mbps), making it suited for light-to-moderate throughput environments such as branch office surveillance systems, small retail locations, or backup targets for remote sites. RAID support allows mirroring or striping of internal drives, protecting against single-disk failure in critical retention scenarios.
Compatibility
The SC101TNA integrates with any network infrastructure supporting standard Ethernet connectivity. It works with surveillance management systems and VMS platforms that support network-attached storage targets via CIFS/SMB or iSCSI protocols. Confirm your NVR or VMS software supports network storage mounting before deployment. Fast Ethernet throughput (100 Mbps max) is sufficient for single-camera or low-channel-count recording streams but will throttle simultaneous backup operations on systems with higher bandwidth demands.
Installation Notes
Mount in a secure location with adequate ventilation—avoid stacking or enclosures that restrict airflow to the drive bay. Connect via standard RJ-45 Ethernet to your network switch. Assign a static IP address to simplify ongoing management and backup scheduling. Ensure power outlet is protected by surge suppression or UPS, as sudden loss of power during write operations risks data corruption in RAID configurations.
