Lifesafety Power FPO75-C4PD8PE2M 4-Output Power Supply

Overview

The FPO75-C4PD8PE2M is a four-output 12VDC power supply designed to distribute backup power across multiple access control readers, door locks, and small-scale security endpoints in commercial installations. This unit addresses the need to centralize power delivery when a single power supply must support both primary and backup loads across an entrance or multi-zone access point. The four independent outputs allow field technicians to assign different loads to separate circuits without parallel wiring, simplifying troubleshooting and reducing single-point-of-failure risk.

Compatibility

The FPO75-C4PD8PE2M integrates into access control architectures where distributed 12VDC power is required — typically paired with door controllers, electromagnetic locks, exit devices, and credential readers operating on 12VDC nominal. Confirm input AC voltage availability (standard 120VAC or 240VAC depending on regional supply and unit configuration) and verify each output load does not exceed the rated current per channel to prevent nuisance shutdowns during peak draw.

Installation Notes

Four independent 12VDC outputs provide isolated power paths, reducing crosstalk between high-current loads (solenoids, magnetic locks) and sensitive signal circuits (readers, keypads). Verify AC inlet voltage matches local utility supply before installation. Wire each output according to National Electrical Code (NEC) requirements for low-voltage circuits; confirm all terminals are torqued to manufacturer specification and secured with appropriate strain relief at the enclosure entry. Battery backup capability (if included in your configuration) requires periodic testing and replacement intervals per the manufacturer's maintenance schedule.