Lifesafety Power FPO75-2D8PE1 75W 16-Output Power Supply
Overview
The FPO75-2D8PE1 is a 75W power supply purpose-built for small-to-medium distributed surveillance and access control deployments. It delivers 6A at 12VDC or 3A at 24VDC across 16 individually supervised Class 2 outputs, each capped at 2.5A — critical for protecting mid-range IP camera arrays and door controllers from overcurrent without oversizing infrastructure. The dual-bus architecture (Bus1/Bus2 selectable per output) allows logical segmentation of loads without requiring separate power units, reducing panel clutter and simplifying troubleshooting in constrained equipment rooms.
Compatibility
The FPO75-2D8PE1 integrates with IP cameras and auxiliary devices drawing 12V or 24V at loads under 2.5A per channel. Typical fits include turret and compact bullet camera strings (3–5 units per output depending on draw), door magnetic locks rated for 24V, and auxiliary relay modules. Output supervision enables monitored circuits — a fault on any single output does not cascade. Pair with a PoE switch for sites mixing PoE and conventional 12/24V devices; the FPO75-2D8PE1 handles non-PoE legacy endpoints and access control separately.
Installation Notes
The E1 enclosure footprint (14H × 12W × 4.5D inches) fits standard 19-inch rack rails or wall-mount on 4-inch centers. Input voltage required (not specified in evidence); confirm local supply rating before commissioning. Each output's 2.5A limit means load calculations are mandatory — exceeding 2.5A per output will trigger supervision and shut that channel. Install in a temperature-controlled environment; temperature range not specified in available evidence. Wire outputs individually per circuit isolation requirements; no shared grounds between Bus1 and Bus2 unless explicitly configured.
