Lifesafety Power FPO150/250-2C82D8PE8M1 Dual-Channel Power Supply

The FPO150/250-2C82D8PE8M1 is a redundant power distribution module designed to supply and supervise multiple security devices in integrated access control and surveillance deployments. Two independent output channels allow separate supervision and power budgeting for cameras, door controllers, and auxiliary loads—a critical requirement when you need to isolate faults without cascading system failure.

Overview

This dual-output architecture is particularly useful in warehouse and manufacturing environments where surveillance systems must operate independently from access control infrastructure. By segregating power channels, you can provision one for networked video infrastructure and a second for legacy or analog-era devices, or use both channels for redundant feeds to critical zones. The two-channel design also simplifies troubleshooting: a fault on one output does not starve the other.

Compatibility

Consult the power supplies category and your system integrator for detailed compatibility with your existing access control systems and IP surveillance infrastructure. The FPO150/250-2C82D8PE8M1 fits into Lifesafety Power's distributed power ecosystem; verify input voltage and output current ratings against your panel and device datasheets before procurement.

Installation Notes

Dual-channel power supplies require careful load balancing across outputs to avoid asymmetric current draw and thermal stress. Confirm that each output's amperage does not exceed manufacturer limits under worst-case load conditions. Wiring must be sized per NEC Article 430 for motor circuits if auxiliary relays or solenoids are present. Verify supervision and fault signaling paths are properly terminated in your master control panel.