HPE P86414-B21 Power Supply Hot-Plug Cord

The HPE P86414-B21 is an 800-watt flex-slot power supply cord rated for 125V AC input across 100–240V range. This is a replacement or spare power module for HPE rack and blade infrastructure — the kind you deploy when you're building out a surveillance NVR cluster or replacing a failed PSU in an existing enclosure without taking the whole system offline.

Overview

This is a hot-plug power device using the IEC 60320 C14 connector standard, meaning you can swap it in or out without powering down the chassis (assuming your HPE platform supports hot-swap PSUs, which most modern enclosures do). The 1.83-meter cable length fits standard server-room runs from rack PDU to appliance. 94% efficiency means minimal waste heat — important in dense surveillance deployments where thermal headroom is already tight. Rated for 50–60 Hz frequency, so it works on North American and international grids.

Compatibility

This cord is designed for HPE C5 flex-slot systems and compatible HPE server and storage platforms that accept modular PSUs with C14 input connectors. If you're replacing an existing HPE power module in an NVR or surveillance server, confirm your chassis part number matches the HPE documentation for this model — cross-platform compatibility is not guaranteed. Verify with your HPE system documentation or pre-sales engineering before ordering if you're uncertain about chassis revision.

Installation Notes

Ensure the host system is powered off or supports hot-swap power modules before disconnecting or inserting the cord. The IEC 60320 C14 connector is keyed and will only fit one way. Route the 1.83-meter cable to avoid sharp edges or pinch points near server racks. Do not exceed the 800W power budget — if your surveillance system's total load exceeds this, you'll need a higher-wattage variant or additional power supplies depending on your enclosure's design.