Viking Electronics PNL60-BK E-60 Series Replacement Faceplate in Textured Black
Overview
The PNL60-BK is a replacement faceplate with color-matching screws and LED light pipe, designed specifically for Viking Electronics E-60 Series double gang VoIP entry phones. If an existing E-60 installation has a damaged, scratched, or faded front panel, this is the direct swap — no new phone unit required. The textured black finish matches the factory appearance of black-variant E-60 phones, keeping the installed unit visually consistent in lobbies, corridors, and access-controlled entry points where appearance matters alongside function.
Compatibility
The PNL60-BK is purpose-built for the Viking E-60 Series entry phones, including the E-60-BK and E-60-BK-EWP double gang models. It is not a universal faceplate — fit is specific to the E-60 double gang form factor (faceplate dimensions 123.8 mm x 125.4 mm x 4.3 mm), mounting in a standard double gang box. The included LED light pipe aligns with the E-60's built-in call indicator, so call-status visibility is preserved after the swap. If your E-60 install is flush-mounted in drywall or a surface enclosure, this replacement maintains the same flush profile. For beige or brown finish installations, a color-matched variant is available in the same PNL60 family — verify the finish code before ordering. See the full intercom and access control accessories lineup for related hardware.
Installation Notes
Mounting follows the same double gang box footprint as the original factory faceplate — no drilling or new penetrations required on a like-for-like swap. The phone unit itself (72 mm x 46 mm x 42 mm) remains in place; only the front panel is replaced. Operating environment carries over from the host E-60: rated -40°C to 60°C (-40°F to 140°F) and up to 95% non-condensing humidity for standard installations, or up to 100% humidity on EWP-variant deployments. Color-matching screws are included, so no additional hardware is needed for a clean finish. Review the entry phone selection guide if you are evaluating a full unit replacement rather than a faceplate swap.
