NETGEAR AXC763-10000S 3M SFP+ Direct Attach Cable

Overview

The AXC763-10000S is a 3-meter passive SFP+ direct attach cable built for 10 Gigabit Ethernet connections between compatible network switches, routers, and server infrastructure. Because it's passive—no active electronics, no power consumption—you eliminate a failure point and avoid the cost and complexity of powered DAC modules. The 3-meter length handles typical rack-to-rack or switch-to-server distances in data centers and enterprise network closets without signal degradation. At 10 Gbps line rate, it delivers the throughput your infrastructure needs with zero added latency.

Compatibility

Works with any network equipment featuring standard SFP+ ports operating at 10 Gigabit Ethernet speeds. Confirmed compatible with NETGEAR switches and routers that support SFP+ connectivity, including Pro AV modular switches and 10G smart managed lines. Verify your specific model's SFP+ port specification before ordering—not all devices support 10G DAC passive cables (some require active transceivers for longer runs or specific firmware versions).

Installation Notes

Insert both connectors fully into the SFP+ ports until you hear or feel a click—partial seating will cause intermittent errors or complete link failure. The passive design means no additional power cabling or module configuration is required; link negotiation happens automatically once both ends are seated. Keep cable slack minimal in high-vibration environments (data center airflow, equipment racks) to avoid connector micro-motion failures. Test the link light immediately after installation—solid green indicates proper seating and negotiation.