NETGEAR AXC7615-10000S 15M SFP+ Direct Attach Cable

Overview

The AXC7615-10000S is a 15-meter SFP+ direct attach cable (DAC) for 10 Gigabit Ethernet connections between network switches, NVRs, and data center appliances. At this length, it bridges the gap between short passive DAC runs (7–10m) and long-haul fiber—eliminating the cost and complexity of inline optics or signal regeneration for mid-range rack-to-rack or switch-stack wiring in facilities where dedicated fiber conduit is not installed.

Compatibility

Works with any network device equipped with an SFP+ port rated for 10GbE DAC operation. This includes enterprise-class switches, network interface cards (NICs), and appliances with SFP+ connectivity. Before purchase, verify your hardware supports either passive or active DAC mode; some vendors restrict DAC compatibility to specific port configurations or firmware versions. Confirm in your device's port specifications or contact the manufacturer if uncertain.

Installation Notes

At 15 meters, this cable approaches the practical limit for passive DAC operation. Check your equipment documentation to determine whether passive or active DAC support is available on your SFP+ ports. No special tools or termination are required—connect both ends directly to the SFP+ ports and secure the latches until they click. Route the cable away from high-current power runs and heat sources to avoid signal degradation. Avoid kinking or applying sharp bends near the connectors, which can damage internal twinax conductors and cause intermittent link loss.