2N 01339-001 IP Force HD Camera Keypad Intercom Controller
The 2N 01339-001 is a hardened IP intercom station purpose-built for outdoor access control and visitor verification in commercial, educational, and industrial facilities. This wired controller integrates HD video capture, numeric keypad authentication, and full-duplex audio into a single device, eliminating the need to source separate components for identification, authentication, and communication. Built to survive extreme weather and impact—IP69K rating, IK10 impact resistance, -40°C to +55°C operating range—it handles deployments where standard intercoms fail.
Key Features
- HD Video Capture with ONVIF Streaming: Delivers real-time visitor identification and face-level detail for access verification. ONVIF compliance means the stream integrates directly into your existing VMS (Milestone, Genetec, etc.) without proprietary converters—a real cost saving during system expansion.
- Integrated Numeric Keypad: PIN-based authentication happens on the device itself. No separate access reader required, reducing hardware density and simplifying wiring at the entry point.
- Full-Duplex Audio with Noise Cancellation: Two-way conversation with echo suppression ensures clarity even in noisy loading docks, windy gate houses, or busy reception areas. Remote staff can hear and respond to visitors without confusion.
- IP69K / IK10 Environmental Rating: IP69K handles high-pressure water jets and total dust ingress—typical of outdoor loading zones, car parks, and weather-exposed entry gates. IK10 impact rating (20 joules) withstands vandalism and accidental strikes without component failure.
- PoE Power (10/100 Base-T Ethernet): Draws typical load via standard PoE, eliminating the need for a separate 12VDC or AC power supply at the mounting location. Single-cable deployment reduces installation labor and conduit runs.
- 802.1X Port-Based Network Security: Enterprise IT teams can enforce VLAN isolation and certificate-based device authentication. Essential in regulated environments where network segmentation is mandatory.
- H.264 Compression: Balances HD quality with bandwidth efficiency. Suitable for sites where network throughput is constrained but 720p or 1080p clarity is required for facial recognition or incident documentation.
- Programmable Control Button: Customizable trigger for direct communication, door release signals, or integration with third-party relay modules and access control panels.
Integration & Compatibility
The 01339-001 streams via ONVIF, so it pairs with any standards-compliant VMS. Auto MDI/MDI-X Ethernet negates crossover cable hassles during field commissioning. Numeric keypad events and video snapshots integrate with IP-based access control systems that support SIP or HTTP webhooks for door unlock commands.
Deployment Scenarios
Deploy at building perimeters, gate houses, and warehouse receiving docks where real-time visitor identification and PIN entry reduce tailgating and unauthorized access. Educational campuses use it for after-hours controlled access to labs and secure zones. Multi-tenant properties benefit from unified communications—tenants or security staff monitor video and audio from a central station while granting or denying entry via the keypad trigger.
Typical Specifications
Environmental: IP69K water/dust rating, IK10 vandal resistance, -40°C to +55°C operating temperature. Network: 10/100 Base-T Ethernet with Auto MDI/MDI-X. Power: PoE (802.3af). Compression: H.264 with ONVIF support. Security: 802.1X authentication for network access control.
When to Choose a Different Approach
If your facility needs door release or lock control built into the same housing, consider a full-featured access control panel instead—the 01339-001 is a communications and verification device, not a panel. For indoor-only reception areas where weather hardening is unnecessary, a non-sealed intercom saves cost. If your VMS does not support ONVIF or HTTP integration, confirm compatibility with the manufacturer before purchase.
Frequently Asked Questions
Q: Does the 2N 01339-001 work with Milestone or Genetec?
A: Yes. ONVIF Profile S streaming ensures compatibility with both platforms. Keypad events and snapshots require API integration configured by your systems integrator, but the video stream is plug-and-play.
Q: Can I use the 01339-001 indoors?
A: Yes, but the IP69K/IK10 rating is overkill for a climate-controlled hallway. You'll pay for environmental protection you don't need. For indoor-only, explore non-sealed alternatives in the same family.
Q: What happens if I lose PoE power?
A: The device goes dark. No battery backup is built in. If you need failover, add a PoE-powered uninterruptible power supply (UPS) to your switch or install a backup 12VDC supply at the mounting location. Plan this during design.
Q: Will the -40°C to +55°C range work in my climate?
A: This covers arctic winters to desert heat. If your facility is between -30°C and +45°C, you have margin. Test in-situ if you're at the extremes—thermal mass and wind exposure affect real-world performance.
Q: Can I integrate the keypad with my existing door lock?
A: The 01339-001 has a programmable button and supports relay signaling. Your integrator must wire a relay module to the door lock and tie it to keypad events via the device's HTTP API or SIP hooks.
Q: Is there a warranty?
A: Confirm directly with your distributor or the manufacturer. Standard commercial electronics carry 1–3 year hardware coverage; check your purchase agreement.
Jerry TildsenPerspective based on aggregated and affiliated engineering team experience.
The 2N 01339-001 solves a real problem: outdoor access control sites need video, audio, and entry authentication in a single hardened enclosure. Most integrators cobble together a separate camera, audio speaker-mic, and keypad reader, each with different mounting brackets and power requirements. The 01339-001 consolidates that bill of materials, reducing installation labor and future maintenance touchpoints. The IP69K/IK10 rating isn't marketing theater—it reflects genuine durability for gate houses and loading docks where standard equipment fails within two seasons.
Technical Highlights:
- IP69K / IK10 Environmental Hardening: High-pressure water jets and 20-joule impacts are typical in industrial entry points. This rating keeps the device functional when standard IP66 equipment would fail. Real-world benefit: fewer warranty callbacks and callbacks in exposed locations.
- -40°C to +55°C Operating Range: Covers everything from Canadian warehouse loading docks (winter lows) to Arizona gate houses (summer peaks). No derating needed across most North American climates. Elimates thermal management design overhead.
- H.264 Compression with ONVIF: Balances bitrate and quality for sites with constrained bandwidth. ONVIF Profile S compliance means zero proprietary bridge gear—drop the stream directly into Milestone, Genetec, or any standards-based VMS. Cost savings compound across large deployments.
- PoE Power Draw Under Standard 802.3af Budget: No separate 12VDC or AC supply at the mounting location. Single Ethernet cable handles power and data. Reduces conduit runs and eliminates dual-supply failure modes common in older installations.
Deployment Considerations:
- No built-in battery backup. If mains PoE fails, the device goes dark—plan UPS failover early if 24/7 uptime is contractual.
- Keypad events and relay triggers require API integration; confirm your access control panel or VMS supports HTTP webhooks or SIP signaling before spec-lock.
- Audio quality depends heavily on speaker impedance and wiring. Pair with a quality PA amplifier at the monitoring station, not consumer-grade audio gear.
Deploy the 01339-001 at perimeter gates, warehouse receiving, and educational facility after-hours access points where weather hardening and integrated video are non-negotiable. Reduces capital cost versus separate devices and improves user experience through unified communications and face-level visitor verification.
