Ubiquiti UACC-OADP-SC-APC-50 Connects two cables

Ubiquiti UACC-OADP-SC-APC-50 SC/APC Fiber Optic Adapter

Overview

The UACC-OADP-SC-APC-50 is a passive fiber optic adapter that connects two SC/APC-terminated cables end-to-end. This is the right choice when you need to extend a fiber run, join cable segments, or integrate Ubiquiti optical equipment into an existing SC/APC infrastructure without active electronics or power draw. The adapter maintains signal integrity through a direct mechanical connection — no signal regeneration, no latency penalty.

Compatibility

Works with any fiber optic equipment or cable terminating in an SC/APC connector, including Ubiquiti optical networking systems and third-party SC/APC-based infrastructure. Common deployment scenarios: rack-mounted fiber termination in network closets, field extensions between rooftop optical gear and building distribution frames, and cable segment joining in equipment racks where pre-terminated jumpers are stocked separately.

Installation Notes

Install the adapter between two SC/APC-terminated fiber cables — insert each connector into the opposite ends of the adapter barrel until you hear a click. The SC/APC angled polish design ensures low back-reflection loss suitable for long-haul optical runs. No tools required beyond standard fiber termination practices. Verify connector cleanliness before insertion (dust on ferrules causes signal loss). Suitable for indoor network closets and outdoor field deployments where environmental protection (conduit, patch panels, or fiber management trays) is provided.