STI EPSPBKT Swing Panel Mount Brackets
Overview
The STI EPSPBKT is a swing panel mount bracket assembly for electric strike hardware in access control installations. Operating at 9VDC, this bracket solves the installation problem of mounting electric strikes on swing door frames where panel-mounted configuration is required—typical in retrofit scenarios or where jamb space is constrained. This is a structural mounting accessory, not a strike itself; pair it with a compatible 9VDC electric strike to complete the assembly.
Compatibility
The EPSPBKT is designed for integration with 9VDC electric strike systems commonly deployed in commercial access control. Verify your specific strike model's mounting pattern and voltage before ordering. The bracket accommodates swing door applications where the strike must be mounted to the door frame panel rather than mortised into the jamb. If your system uses DC-powered strikes (not AC) and your door frame allows panel-surface mounting, this bracket is a fit; if your strike requires jamb mortising or your voltage differs, confirm with your integrator before purchase.
Installation Notes
Mount the bracket assembly to the swing door frame using the provided hardware. Drill through the mounting holes (7mm masonry drill bit recommended for concrete/block frames) and secure with appropriate wall fixings for your substrate type. Route 9VDC power and signal wiring through the frame cable entries; use gaskets to seal unused entry holes and protect against moisture ingress. Position the bracket to align the strike with the keeper strike on the door frame—misalignment will cause binding or incomplete locking. Test strike operation (energize/de-energize cycle) after installation to confirm proper engagement.
