Lifesafety Power RGM75-D8P 75W Regulated Power Supply

Overview

The RGM75-D8P is a 75W regulated DC power supply designed to support distributed IP cameras and network-powered security endpoints in small-to-medium installations. It provides selectable output — either 12VDC at 6A or 24VDC at 3A — allowing you to match your power infrastructure to device voltage requirements without stocking multiple SKUs. This matters in mixed-voltage deployments: a single unit can power a cluster of 12V turrets or domes, or serve as a backup for 24V PoE midspan applications where line-powered delivery is constrained. The 75W capacity handles typical camera power budgets (3–12W per camera) across 6–12 endpoints depending on duty cycle and load profile.

Compatibility

The RGM75-D8P works with any 12VDC or 24VDC-powered camera or endpoint that draws within the rated current envelope. Verify the target device's power specification against the selected output voltage and confirm total current draw does not exceed 6A (12V) or 3A (24V). It integrates into centralized power supply architectures where multiple cameras feed from a single remote PSU, common in warehouse automation and large-footprint surveillance floors. For PoE switch-based deployments, this unit serves as a redundant or supplemental supply for non-PoE devices or as a backup power layer in hybrid installs.

Installation Notes

The RGM75-D8P requires AC mains input (110–240V). Select your target voltage using the unit's output selector (12V or 24V) before installation — do not change this under load. Wire the positive and negative terminals to your camera harness or distribution block using appropriately sized conductors; over-current protection at the device end is recommended. Ensure ambient operating temperature remains within manufacturer limits; verify thermal clearance around the enclosure to prevent de-rating under high-load sustained operation.