Lifesafety Power FPO75-C8D8E1 8-Output Fused Power Supply Cabinet

Overview

The FPO75-C8D8E1 is a 75W cabinet-mount power distribution unit designed to provision and supervise multiple low-voltage security devices from a central location. Eight independent lock outputs (typically for electric strikes or mag locks) and eight auxiliary circuits (3A fused each) allow you to distribute 12VDC or 24VDC across a small-to-medium access control or camera system footprint. Total capacity: 6A at 12VDC or 3A at 24VDC—appropriate for deployments needing distributed power without a full rack-mount UPS.

Output Configuration

Each of the eight auxiliary outputs is independently fused at 3A, preventing a single device fault from collapsing power to the entire panel. The eight lock circuits support standard solenoid locks and mag locks used in card-reader integrated systems. This architecture is typical for small commercial access control cabinets serving single-building or multi-zone warehouse environments where modularity and fault isolation matter more than extreme power budget.

Compatibility

The FPO75-C8D8E1 integrates with access control systems and security installations using 12VDC or 24VDC distributed power topologies. It is commonly paired with access control panels and card readers that require segregated power paths. For larger multi-camera or multi-reader sites, this unit serves as a secondary power distribution point downstream of a central power supply or UPS.

Installation Notes

Enclosure design (E1 rating per Lifesafety Power nomenclature) specifies environmental and electrical containment. Mount vertically in a secure cabinet or wall-mount location with adequate ventilation for continuous 75W dissipation. Verify input voltage (12VDC or 24VDC source) before wiring; outputs are fused, but input protection is dependent on upstream supply configuration. All eight lock circuits and all eight auxiliary outputs must be individually terminated—no daisy-chaining between outputs.