Lifesafety Power FPO75-B100M8NLCE2M 75W Managed Power Supply

Overview

The FPO75-B100M8NLCE2M is a 75W managed distribution power supply delivering either 6A at 12V or 3A at 24V — your choice depends on the voltage your security devices require. The unit includes eight independently fused output channels, each rated at 3A maximum. This architecture prevents a single short or overload on one device from taking down your entire installation. Deploy this where you're running multiple cameras, access control readers, or door locks on a single power backbone and need per-device protection without daisy-chaining wall supplies.

Compatibility

The FPO75-B100M8NLCE2M works with any 12V or 24V surveillance device — cameras, readers, electric strikes, magnetic locks, and auxiliary modules that draw under 3A per unit. It is commonly paired with legacy and modern security systems running fixed voltage distribution rather than PoE-based installs. Verify your device voltage (check the label) before wiring; you configure the supply for either 12V or 24V operation, not both simultaneously.

Installation Notes

The eight outputs are individually fused at 3A per channel — a design choice that simplifies troubleshooting in the field. If one fuse blows, you know exactly which device or branch faulted; replace the fuse and power returns only to that output. Total 75W capacity means you cannot load all eight channels simultaneously at maximum (3A × 8 = 24A at 12V would exceed 75W at that voltage). Plan your load distribution: if running 12V, expect roughly 6A total available current across all eight channels before voltage sag becomes an issue. For 24V operation, you get 3A total across the distribution. Wire the supply using appropriately sized conductors matched to your channel load and run length — oversizing wire from the supply to distant devices prevents voltage drop that could cause device brownout or reset cycles.