Lifesafety Power FPO75-B100C4PD8PE4 Four Door Access Control Power Supply

Overview

The FPO75-B100C4PD8PE4 is a four-door access control power distribution unit designed to supply and manage power to door strike mechanisms, mag locks, and related access control hardware in small-to-medium security installations. It centralizes power management and output control across four independent door circuits, reducing wiring complexity and providing supervised distribution to each output — critical in deployments where you need to detect if a strike has failed or been tampered with.

Compatibility

This unit integrates with access control panels that support relay-switched door strike outputs or controlled 12/24VDC distribution. It is commonly paired with systems supporting supervised door strike circuits — check your access control system documentation to confirm it can drive the relay inputs on this unit. The four independent outputs allow simultaneous control of four separate door strikes or lock devices, each with its own supervision feedback loop.

Installation Notes

Install in a secured, temperature-controlled cabinet or electrical enclosure near the access control panel. Wire each output to its corresponding door strike mechanism; ensure proper voltage selection (12VDC or 24VDC, depending on your strike hardware) before powering the unit. Supervision wiring provides feedback to detect open-circuit or short-circuit faults on each output line — required to meet ADA and commercial security standards in most jurisdictions. Consult your local electrical code and security integrator for proper conduit sizing and circuit protection.