ELO Touch E263989 DDR4 SODIMM Memory Module

Overview

The ELO Touch E263989 is a 16GB DDR4 SODIMM module operating at 2666MHz — a memory upgrade for ELO TouchSystems products that support second-slot DDR4 expansion. This module addresses capacity constraints on systems running multi-camera surveillance software, VMS clients, or edge analytics workloads where base memory proves insufficient. The 2666MHz speed matches standard ELO system architectures without requiring BIOS tweaks or compatibility workarounds.

Compatibility

The E263989 is a second-slot (2ND) DDR4 SODIMM designed for ELO TouchSystems that feature DDR4 memory upgrade capacity. Verify your specific ELO system supports DDR4 expansion before ordering — some legacy ELO models use DDR3 or soldered memory. Confirm the system manual or contact ELO support with your exact model number to confirm slot availability and maximum supported capacity.

Installation Notes

Power down the system completely before installing. Locate the SODIMM slot (typically on the motherboard or memory riser card inside the enclosure). Align the notch in the module with the key in the slot, then insert at a 45-degree angle and press down firmly until the retention clips snap into place on both ends. No tools required. After installation, power on and enter BIOS setup to confirm the system recognizes the full 16GB capacity. Some systems may require firmware updates to support maximum memory — check ELO's support portal for your model.