HPE DL360 GEN11 8SFF PCIE CBL KIT - P48909-B21

HPE P48909-B21 DL360 Gen11 8SFF PCIe Cable Kit

Overview

The HPE P48909-B21 is a PCIe cable kit designed specifically for the HPE ProLiant DL360 Gen11 server in 8SFF (Small Form Factor) drive configurations. If you're expanding PCIe connectivity — adding a storage controller, NIC, or GPU — without the correct internal cabling, the slot goes unused. This kit provides the cables needed to route PCIe signal from the riser or backplane to the target slot, resolving a common gap when ordering the DL360 Gen11 with non-default PCIe configurations or when retrofitting additional cards post-deployment.

Compatibility

Designed for the HPE ProLiant DL360 Gen11 in 8SFF drive bay configurations. Per HPE's platform support data, this cable kit is also compatible with the broader HPE ProLiant Rack/Tower/BladeSystem and Synergy server platforms where applicable PCIe routing requirements match. Confirm your specific chassis configuration and PCIe slot assignment against HPE's QuickSpecs for the DL360 Gen11 before ordering — not all PCIe slots in every DL360 Gen11 build require this kit, and the 8SFF chassis designation is a hard prerequisite.

Installation Notes

This is an internal cable kit — installation requires opening the server chassis and routing PCIe cables to the designated connectors. The kit ships at approximately 1.0 lb and measures 13.50 x 8.10 x 0.30 in, sized to fit the DL360 Gen11 internal bay routing paths. Follow HPE's server maintenance procedures and observe standard ESD precautions. No additional tools beyond what HPE specifies for DL360 Gen11 internal access are required. Interface type is PCIe — verify slot and connector compatibility with your specific riser configuration before installation.