Geovision 81-SRFD190-00US GV-RU9003 PTZ Camera Cable

Overview

The 81-SRFD190-00US is a specialized cable assembly designed for Geovision GV-RU9003 IP PTZ cameras. This cable delivers the signal paths required for pan-tilt-zoom motor control and network communications — meaning your PTZ head can actually pan, tilt, and zoom instead of sitting static. Use it when commissioning new GV-RU9003 systems or replacing a failed cable run in an existing PTZ installation.

Compatibility

This cable is built specifically for Geovision GV-RU9003 PTZ cameras. Verify your camera model matches the GV-RU9003 designation before ordering — PTZ cables are not interchangeable across brands or even across Geovision PTZ product lines. Confirm the cable connector type and pinout match your camera's input port.

Installation Notes

PTZ cables carry both network (Ethernet) and control (motor) signals in a single shielded bundle. Route the cable away from high-current power lines, welding equipment, or radio transmitters to avoid servo noise that degrades pan-tilt smoothness. Support the cable every 3–4 feet on overhead runs to prevent strain on the camera connector. Use cable clips or spiral wrap — do not tape, as compression can damage the shielding over time. Avoid sharp bends near the connectors; minimum bend radius is typically 1 inch for this cable type. Test pan, tilt, and zoom movement before closing out the install.

What's in the Box

• 1x GV-RU9003 PTZ Camera Cable (81-SRFD190-00US)