Geovision GV-FER5702 Tilting Wall Mount
The GV-FER5702 is a tilting wall mount bracket built for Geovision PTZ camera installs where you need to adjust downward tilt angle after mounting — common on exterior walls covering entry points, parking areas, and loading docks. It attaches directly to a wall surface and lets you fine-tune camera aim without repositioning the mounting hardware itself.
Compatibility
The GV-FER5702 is designed for Geovision's IP PTZ camera line (cable routing sized for PTZ-class camera cabling). Confirm base thread pattern and weight rating against your specific PTZ model before ordering — mismatched mount-to-camera fit is the most common install error on tilt brackets.
Installation Notes
Rated to carry up to 1.15 lb of camera weight, so verify your camera body falls within that limit before mounting — exceeding it stresses the tilt joint over time and risks drift in aim angle. The bracket ships in white to match common Geovision camera housings, keeping the install visually clean against light-colored walls or soffits. Internal routing accommodates PTZ camera cable runs, which keeps cabling out of the weather and off the wall face — important for maintaining a clean look and avoiding UV/moisture exposure on exposed jacketing. Footprint is 7.00 x 7.00 x 2.00 in, so confirm wall clearance and stud spacing before drilling.
Pair this bracket with a PTZ camera from the Geovision catalog for a complete wall-mounted setup, and check a mounting and coverage planning guide if you're still finalizing camera placement. For runs requiring mid-span power, a compatible PoE switch keeps the install to a single cable back to the closet, and a matching mount and bracket accessory can extend reach on parapets or poles where a flat wall isn't available.
