Geovision GV-PA903BT-140 Pole Mount Adapter
The GV-PA903BT-140 is a pole mount adapter plate that lets you install a compatible Geovision dome or bullet camera on a pole instead of a flat wall or ceiling surface — the fix you need for parking lots, perimeter fence lines, and yard poles where there's no flat vertical surface to bolt a bracket to. It bridges the camera's mounting base to a standard pole diameter and routes the cable run internally, keeping the installation weatherproof and clean instead of leaving exposed cable loops for someone to snag or cut.
Compatibility
The adapter is built around a PoE++ (802.3bt) pass-through rated for up to 95W at 54V DC, which matters because it lets you run PTZ domes or heated camera housings that draw more power than standard PoE+ (802.3at) can deliver — the adapter doesn't bottleneck the power budget between the switch and the camera. Gigabit Ethernet support over CAT5e means you're not capped on bandwidth for multi-megapixel or 4K streams either. Confirm base-plate compatibility against your specific Geovision camera model's mounting pattern before ordering.
Installation Notes
Housing is finished in white to match standard Geovision dome and bullet enclosures, and the unit is rated for -0°C to 40°C (32°F to 104°F) operation — a mid-range rating, so verify it against your climate before deploying in extreme heat or sub-freezing environments. At 2 lb and roughly 9.5 x 7.5 x 4 in, it's light enough for one installer to mount and secure to a standard pole without additional bracing. Because it passes PoE++ at up to 95W, confirm your upstream switch or injector actually supports 802.3bt Class 8 output — feeding it from a standard PoE+ source will limit the camera to lower-wattage operation.
