Panduit FRFWC12X4LYL FiberRunner 4-Way Cross Fitting
The Panduit FRFWC12X4LYL is a four-way horizontal cross fitting engineered for 12x4 FiberRunner cable management systems in high-density fiber installations. This intersection component lets you create perpendicular pathway crossings while maintaining proper bend radius protection across all four legs—critical when routing trunk cables through data center hot aisles, telecom central offices, or multi-tier rack deployments where horizontal runs converge from opposite directions.
Key Features
- Four-way cross configuration supports 12x4 FiberRunner channels at 90° intersections with two 12x4 outlets
- Polycarbonate/ABS blend construction balances impact resistance with dimensional stability across -40°C to +65°C operating range
- UL 2024A certified for optical fiber cable routing assemblies—meets code requirements for plenum and riser pathway systems
- Telcordia GR-63-CORE and NEBS Level 3 compliant for seismic zone deployment and central office environmental spec
- Yellow high-visibility color simplifies fiber pathway identification in mixed-infrastructure environments
- 22.25" × 22.25" footprint with 4.22" height accommodates up to 864-count trunk cables at manufacturer bend radius spec
- Snap-together assembly integrates with FiberRunner 12x4 channels and fittings without fasteners or adhesive
Data center fiber distribution demands pathway components that protect expensive single-mode and multimode trunk cables while supporting moves, adds, and changes without service interruption. The FRFWC12X4LYL cross fitting addresses the structural challenge at four-way intersections: you need rigid support to prevent cable sag under weight (twelve 72-fiber trunks in a 12x4 channel can exceed 40 lbs), smooth interior transitions to avoid jacket abrasion during pulls, and sufficient cross-sectional area so fill ratio stays below 50% per TIA-569 guidelines. Panduit's polycarbonate/ABS formulation delivers 12,500 psi tensile strength and passes UL 94 V-0 flammability rating, so the fitting won't deform under load or contribute to flame spread in the unlikely event of a plenum fire. The 107.2mm internal height gives you margin when routing pre-terminated trunk assemblies with bulky MTP/MPO connectors—pull tension stays manageable and you avoid the jacket kinking that causes insertion loss drift six months post-install.
Deploy the FRFWC12X4LYL where your backbone fiber runs intersect overhead ladder rack, under raised floor, or along perimeter walls in Tier III/IV facilities. Common scenarios: converging east-west and north-south trunk runs above hot aisle containment; perpendicular feeds from equipment distribution areas to meet-me rooms; cross-connect pathways linking optical distribution frames in multi-building campuses. The four-outlet design eliminates the need for stacked tees or creative splicing of mismatched fittings, so your pathway maintains consistent bend radius protection and your installation passes structured cabling audits on first inspection. Yellow colorway works especially well in mixed-service environments—reserve yellow for fiber, use black or gray FiberRunner for copper Cat6A trunks, and your techs can identify the right pathway during after-hours maintenance without pulling cables to check jacket markings. The fitting integrates with Panduit's full 12x4 accessory line: vertical drops, radius limiters, wall brackets, and snap-on covers that convert open-trough to enclosed raceway when you need dust protection or physical security compliance.
One fitting per package. RoHS compliant for EU and California installations. Telcordia GR-63-CORE qualification means this component has passed the same seismic simulation, thermal shock, and fire/smoke tests required for carrier-class telecom equipment—if you're building a SSAE 18-audited colocation facility or a 911 PSAP with five-nines uptime requirements, the FRFWC12X4LYL meets the infrastructure resilience standard your contract and insurance underwriter expect.
