Panduit CLT150F-X4F Corrugated Loom Tubing

The Panduit CLT150F-X4F corrugated loom tubing delivers cable protection for pre-terminated harness assemblies and retrofit installations where threading individual wires isn't practical. The longitudinal slit design lets you snap bundles into the 1.5-inch bore without disconnecting terminations or pulling cable back through confined pathways. Polyethylene construction resists impact and abrasion in equipment racks, cable trays, and above-ceiling runs where cables cross structural edges or pass through wall penetrations. Ships in FiberRunner Yellow for high-visibility marking of fiber-optic or low-voltage data runs.

Key Features

Longitudinal slit accepts pre-assembled harnesses without disassembly — snap cables into the 1.58" (40mm) inside diameter and secure with cable ties

Corrugated polyethylene construction provides crush resistance and flexibility for routing around obstacles and through tight bends

UL 94 HB flammability rating suitable for plenum-adjacent and general indoor cable management applications

10-foot (3.05m) length covers typical rack-to-patch-panel runs or equipment-room cross-connects in a single piece

FiberRunner Yellow color provides visual differentiation for fiber-optic trunk lines, security system low-voltage circuits, or AV signal paths

RoHS compliant polyethylene rated for continuous operation up to 122°F (50°C)

The slit-wall design solves the productivity problem of protecting cables after connectors are installed. In retrofit scenarios — adding cameras to an existing building, upgrading access control panels, or running new AV feeds through finished spaces — you're often working with pre-terminated patch cords, pigtails, or factory-assembled harnesses that won't pass through solid conduit. The CLT150F-X4F splits open along its length so you position the tubing around the bundle, press the slit closed, and cinch it in place with cable ties at 12–18 inch intervals. The corrugated profile maintains a 1.58-inch clear bore even when bent, preventing kinks that would stress conductors or crush fiber-optic jackets. Polyethylene's low friction coefficient lets cables slide during thermal expansion cycles without binding, and the material resists common cleaning solvents and lubricants found in industrial environments.

Deploy this tubing in equipment rooms where cables transition from enclosed ladder rack to open vertical managers, protecting against abrasion from sharp rack edges during moves-adds-changes. Use it inside enclosures to isolate high-current DC battery feeds from low-voltage control wiring, or bundle plenum-rated cables before they enter air-handling spaces to simplify visual inspection and maintain separation from HVAC ductwork. The 10-foot length suits most intra-rack and short inter-rack runs without excess material or mid-run splices. Pair with Panduit cable ties (sold separately) at each corrugation peak to prevent axial slippage under vertical load. FiberRunner Yellow provides immediate identification during troubleshooting or adds-on-change work orders, reducing the risk of accidentally cutting into live fiber trunks when adjacent copper bundles need service.

The UL 94 HB flammability rating meets baseline fire-safety requirements for general building spaces and equipment rooms not subject to plenum mandates. The 122°F continuous-temperature ceiling accommodates normal HVAC conditions and moderate heat rise near power distribution units, though installations within 6 inches of high-wattage transformers or in direct sunlight through windows may require higher-rated sleeving. RoHS compliance ensures the tubing contains no restricted heavy metals, satisfying procurement requirements for federal facilities, healthcare systems, and enterprises with global environmental standards. Each package includes one 10-foot section; calculate your total linear footage requirement and order in multiples to minimize mid-run joints and material waste.