Comelit 6617 Flush-Mounted Box For Drywall
Overview
The Comelit 6617 is a flush-mounted installation box designed to recess Icona S intercom system components into drywall surfaces. This accessory solves the common problem of surface-mounted boxes breaking sight lines in residential and commercial environments — instead, the 6617 sits behind the wall plane, leaving only the monitor visible. Dimensions of 129×129×50 mm (approximately 5.1×5.1×2.0 inches) allow compact integration into standard wall cavities. Deploy this where new construction or retrofit work permits in-wall rough-in and you need a finished appearance without exposed brackets or conduit.
Compatibility
The Comelit 6617 is designed specifically for the Icona S series monitors and intercom system components. Confirm your Icona model number against the system documentation before ordering — this box does not accommodate other Comelit series or third-party intercom panels. Suitable for both plasterboard (drywall) and cement walls; use appropriate fasteners and backing support for cement installations.
Installation Notes
Flush mounting requires wall cavity preparation: cut an opening to the box footprint, run wiring (power and signal lines) through the rear knockouts, and secure the box to wall studs or blocking using provided fastening points. Ensure adequate backing support behind the drywall to prevent flex or rocking once the monitor is mounted. Wire management through the box should keep bundled cable runs clear of monitor mounting points to avoid pinching or signal interference. Environmental limits for standard drywall installation are interior use only — moisture-prone areas (bathrooms, exterior walls with high condensation risk) may require vapor barrier and sealed cable entries to protect electronics.
What's in the Box
- 1× Comelit 6617 flush-mount box
