Code Blue CB9S00184 PoE Ethernet Cable IP68
Overview
The Code Blue CB9S00184 is an IP68-rated Ethernet cable engineered to deliver both data and Power over Ethernet (802.3af) across sealed connectors in outdoor and industrial environments. The IP68 rating means complete dust ingress protection and temporary submersion up to 1 meter — a critical requirement when running cabling through wet equipment rooms, cable trays exposed to washdown, or underground conduit near drainage. Use this cable where standard Cat5e or Cat6 would fail: fence-mounted access points, rooftop antenna installations, exterior dome camera drops, and equipment rooms subject to humidity or spray.
Compatibility
The CB9S00184 integrates with any PoE-compatible network equipment conforming to 802.3af standards, including IP cameras, wireless access points, VoIP phones, and edge-mounted network switches. The sealed connectors work with standard RJ-45 terminations on the device end; however, verify that your endpoint equipment can accept a weatherproofed connector variant if the cable uses integrated or molded seals. Compatible with surveillance infrastructure, access control network gear, and security integrators' standard PoE-powered hardware deployments.
Installation Notes
IP68 sealing requires proper connector mating and strain-relief management. Avoid excessive flexing near termination points — the sealed jacket is protective but not designed for frequent repositioning. When installed in conduit or overhead runs, support the cable every 2–3 feet to prevent stress on sealed connectors from sagging. Do not exceed standard Ethernet bandwidth limits or PoE power budgets (802.3af supplies up to 13W); high-power PoE+ (802.3at) devices may require verification that this cable variant supports the higher wattage without degradation. Confirm connector compatibility with your target equipment before purchase — some sealed variants use proprietary terminations.
What's in the Box
- 1x Code Blue CB9S00184 PoE Ethernet Cable IP68
