Lifesafety Power products
-
Lifesafety Power
SKU: FPO150/250-2C8P2D8PE8H1
Lifesafety Power FPO150/250-2C8P2D8PE8H1 FPO150/250-2C8P2D8PE8H1
- Delivers 400W at 12V and 24V to power up to 16 doors on Honeywell platforms.
- E8H1 enclosure (36H×30W×4.5D in) supports wall-mount or rack installation.
- Dedicated access control supply; keeps lock/reader circuits isolated from other loads.
$2,760.00 $1,812.99 Save $947.01 -
Lifesafety Power
SKU: FPO150/250-2C8P3D8PE8M
Lifesafety Power FPO150/250-2C8P3D8PE8M 400W Dual Voltage 120 VA
- 400W dual-voltage output supports 12V and 24V DC control circuits in one unit.
- 16 relay outputs drive strike plates, maglocks, and solenoids across multiple zones.
- 24 auxiliary outputs handle gate triggers and status signaling without extra hardware.
$2,437.00 $1,600.99 Save $836.01 -
Lifesafety Power
SKU: FPO150/250-2C83D8PE4M1/P16-A
Lifesafety Power FPO150/250-2C83D8PE4M1/P16-A 150W power supply
- Dual-output design delivers up to 20A/12V or 10A/24V to scale with site load.
- 16 independently fused 3A relay outputs support FAI, failsafe, or failsecure modes.
- E4 enclosure with Mercury LP1502/MR52 support centralizes control for up to 16 doors.
$3,776.00 $2,480.99 Save $1,295.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8PE8H1
Lifesafety Power FPO150/250-2C82D8PE8H1 Dual FPO Buss/Flex Cable
- Dual independent output channels isolate camera, lock, and sensor power rails.
- Fault on one circuit does not interrupt the second output, limiting cascading failures.
- Rack-mount form factor integrates with FPO buss and flex cable modular enclosures.
$2,760.00 $1,812.99 Save $947.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8PE8B
Lifesafety Power FPO150/250-2C82D8PE8B 150W power supply 12A/12V
- Selectable 12VDC/12A or 24VDC/10A output eliminates separate SKUs for mixed-voltage sites.
- Eight 3A relay outputs with per-relay failsafe, failsecure, or FAI modes control door locks predictably.
- Eight isolated Class 2 aux outputs (2.5A each) power readers, keypads, and sensors on two bus groups.
$2,520.00 $1,655.99 Save $864.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8PE8H1-WP-JNJ02
Lifesafety Power FPO150/250-2C82D8PE8H1-WP-JNJ02 400W Dual Voltag
- 400W dual voltage output drives mixed 12V/24V DC loads from a single 120V AC source.
- 16 relay lock outputs support strikes, mag-locks, and momentary devices across one cabinet.
- 16 auxiliary outputs distribute power to sensors and low-draw control signals independently.
$4,425.00 $2,906.99 Save $1,518.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8PBP8M2
Lifesafety Power FPO150/250-2C82D8PBP8M2 400W Dual Voltage 120
- 16 relay lock outputs support strikes, mag-locks, and solenoid devices in one chassis.
- 16 auxiliary outputs power cameras, LEDs, and control signals without added hardware.
- 400W capacity on 120 VAC input eliminates daisy-chained supplies across large deployments.
$1,507.00 $989.99 Save $517.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8PE8H1/P16-C
Lifesafety Power FPO150/250-2C82D8PE8H1/P16-C 150W power supply
- Selectable 150W or 250W output supports 12VDC or 24VDC mixed-voltage deployments.
- Eight individually fused relay outputs prevent fault cascades across locks and strikes.
- Eight supervised aux outputs with Bus1/Bus2 assignment simplify multi-door distribution.
$5,114.00 $3,358.99 Save $1,755.01 -
Lifesafety Power
SKU: FPO150/250-4D8E8P
Lifesafety Power FPO150/250-4D8E8P Power supply board 150W 12A/1
- Dual-voltage output (12VDC/24VDC) eliminates conversion hardware in mixed-device deployments.
- 12A at 12VDC supports up to 144W of connected load across cameras and access control devices.
- Screw-down output terminals simplify field wiring for IR illuminators, readers, and solenoids.
$2,384.00 $1,565.99 Save $818.01 -
Lifesafety Power
SKU: FPO150/250-2C82D8E8V
Lifesafety Power FPO150/250-2C82D8E8V 400W (12V & 24V) 16 lock &
- Delivers simultaneous 12V and 24V output from a single 400W regulated supply.
- 16 supervised lock outputs flag wiring faults per circuit, preventing silent failures.
- Dual-rail topology supports mixed mag locks, card readers, and cameras on one backbone.
$2,512.00 $1,649.99 Save $862.01 -
Lifesafety Power
SKU: FPO150/150-2C82D8E6M1
Lifesafety Power FPO150/150-2C82D8E6M1 150W power supply 12A/12V
- Delivers 12A at 12VDC or 6A at 24VDC from a single 150W supply.
- 16 individually fused relay outputs, each configurable fail-safe or fail-secure.
- 16 DC auxiliary outputs at 3A each enable isolated power buses per circuit.
$2,336.00 $1,534.99 Save $801.01 -
Lifesafety Power
SKU: FPO150-2D8E2
Lifesafety Power FPO150-2D8E2 FPO150-2D8E2
- Dual independent 24VDC channels deliver failover power with zero switching delay.
- Built-in supervision detects supply failure or undervoltage for unattended sites.
- Battery backup support enables AC ride-through for continuous load protection.
$664.00 $436.99 Save $227.01 -
Lifesafety Power
SKU: FLEX-IO-72-CABLE-BOXED
Lifesafety Power Flex-Io-72-Cable-Boxed Flex-Io-72-Cable-Boxed
- Standardizes I/O field wiring for sensor inputs, relay outputs, and supervised circuits.
- Designed for FLEX series control modules, ensuring connector type alignment on deployment.
- Cable assembly form factor simplifies termination and routing within power distribution enclosures.
$28.00 $27.99 Save $0.01 -
Lifesafety Power
SKU: EX-T8-BOXED
Lifesafety Power EX-T8-BOXED Expansion side enclosure for T8
- Adds supplemental output channels to the T8 platform without replacing the base unit.
- Supports PoE distribution, enabling scalable power for cameras and access control readers.
- Side-mount design integrates directly with the T8 enclosure for a compact, modular install.
$699.00 $459.99 Save $239.01 -
Lifesafety Power
SKU: EX-T4-BOXED
Lifesafety Power EX-T4-BOXED EX Expansion Enclosures for T4
- Expands T4 output capacity to support 8+ supervised circuits in a single system.
- Modular design stacks with the T4 base unit, simplifying high-density deployments.
- Compatible exclusively with Lifesafety Power T4 units; verify model docs before ordering.
$599.00 $393.99 Save $205.01 -
Lifesafety Power
SKU: E8V-BOXED
Lifesafety Power E8V-BOXED Enclosure. E8 36" X 30" X6-1/2" Blk
- 36"×30"×6.5" profile fits standard 16" and 24" stud-center wall cavities.
- Vertx back plate supports 35mm DIN rail, M5/M6 fasteners for organized terminations.
- Top and side knockouts accept conduit entries up to 1.5" NPT for clean cable routing.
$1,434.00 $941.99 Save $492.01 -
Lifesafety Power
SKU: E8S-BOXED
Lifesafety Power E8S-BOXED Software House Boxed Power Systems 0W
- Accepts 120 VAC, 50/60 Hz single-phase input for standard branch circuit integration.
- Distributes 24 VDC output across multiple protected circuits from one centralized unit.
- Designed for Software House panels, eliminating daisy-chained AC runs in control rooms.
$1,437.00 $943.99 Save $493.01 -
Lifesafety Power
SKU: E8L-BOXED
Lifesafety Power E8L-BOXED Enclosure E8L 36x30x6.5 black
- 36×30×6.5-inch wall-mount profile fits tight equipment rooms without floor space.
- Factory-fitted backplate speeds integration of LifeSafety Power modules and relay boards.
- Black powder-coat finish provides corrosion resistance for indoor and semi-protected environments.
$1,501.00 $985.99 Save $515.01 -
Lifesafety Power
SKU: E8H-BOXED
Lifesafety Power E8H-BOXED Honeywell Boxed Power Systems
- Pre-configured enclosure centralizes power distribution for multi-device security deployments.
- Reduces single-point failure risk versus individual adapters across camera or access control runs.
- Manufacturer-backed Lifesafety Power hardware suits rack or cabinet mounting in enterprise installs.
$1,429.00 $938.99 Save $490.01 -
Lifesafety Power
SKU: E8H1-BOXED
Lifesafety Power E8H1-BOXED Unified Power Integrated Enclosures
- Centralizes power distribution for up to 9 access panels in one enclosure.
- 36W × 30H × 6.5D-inch profile fits retrofit equipment rooms with limited depth.
- Native Pro-Watch integration simplifies commissioning on multi-door deployments.
$1,702.00 $1,117.99 Save $584.01