Lifesafety Power FPO150/250-2C82D8PE8H1-WP-JNJ02 400W Dual Voltage Power Supply

Overview

The FPO150/250-2C82D8PE8H1-WP-JNJ02 is a 400W dual voltage power supply built for access control and security system integration where you need independent voltage outputs to drive multiple load types from one cabinet-mounted source. 120 VAC input delivers two separate voltage rails — a real advantage when your door controllers, electric locks, and readers operate on different nominal voltages. The 16 relay lock outputs and 16 auxiliary outputs mean you can fan power distribution across numerous devices without adding extra supply modules.

Compatibility

This supply pairs with Lifesafety Power cabinet systems and third-party access control panels that accept dual voltage rails on standard power distribution terminals. Verify your control panel's voltage requirements (typically 12V and 24V DC across the dual outputs) and connector pinout before wiring. The relay lock outputs support solenoid strikes, magnetic locks, and momentary-duty devices; auxiliary outputs handle sensor circuits and low-draw control signals. Confirm your panel's input voltage spec matches 120 VAC and that total connected load does not exceed 400W continuous draw across both rails.

Installation Notes

Mount in a climate-controlled equipment cabinet or enclosure rated for wall or rack installation. Verify incoming 120 VAC utility power is on a dedicated 20 amp circuit with proper overcurrent protection upstream — do not share with high-inrush HVAC or lighting loads. Connect the input power terminals using 12 AWG or larger wire if cable run exceeds 50 feet; shorter runs can use 14 AWG. Keep the supply away from direct moisture and dust; if outdoor or wet-location mounting is required, specify an enclosure rated IP54 or higher. Allow 2–3 inches of clearance above and below for airflow cooling.