APC by Schneider Electric APDU10452SW Advanced Switched 3-Phase Rack PDU

Overview

The APDU10452SW is a 3-phase switched rack PDU rated at 17.3kW, 208V, 60A with a 460P9 input connector and 42 individually switched outlets. Switched outlet control means you can remotely cycle power to a locked-up device or sequence startup loads without dispatching a technician to the data center floor — a real operational advantage in high-density or remote-managed environments. At 71.89 inches (182.6 cm) in length, this unit is designed for full-height rack column deployment where outlet density per U is the constraint. The 24.5 lb form factor mounts vertically in a standard EIA-310 rack column.

Compatibility

Designed for deployment in APC NetShelter SX, SV, and VX enclosures that support zero-U vertical PDU mounting — the standard rail and mounting bracket system in these enclosures accommodates the APDU10452SW's full-length form factor. The 460P9 (NEMA L22-60P equivalent, 4-wire 3-phase) input requires a matching 60A 3-phase circuit at the panel; verify your facility's breaker and whip configuration before ordering. The 42-outlet capacity suits high-density compute rows, storage arrays, or mixed security/networking equipment racks where per-port switching matters. Compatible with APC EcoStruxure IT and the APC Network Management Card ecosystem for remote monitoring and outlet-level control.

Installation Notes

Rack mounting is vertical (zero-U) along the side channel of a compatible NetShelter enclosure. Confirm the enclosure side-mounting bracket kit is present before installation — not all NetShelter configurations ship with vertical PDU hardware pre-installed. The 460P9 input plug requires a 3-phase 60A circuit; do not connect to single-phase infrastructure. Unit weight of 24.5 lb should be supported by two technicians during column insertion. Network management card slot allows post-installation addition of remote management capability without removing the unit from the rack.