ATEN 2L7D03DP 10ft DisplayPort Cable
Overview
The ATEN 2L7D03DP is a 10-foot DisplayPort cable designed for use with ATEN KVM switches, matrix switches, and extenders that require a dedicated DisplayPort connection. When deploying multi-monitor or high-resolution AV workstation setups, cable quality and length directly affect signal reliability — the 2L7D03DP provides a factory-terminated, commercial-grade link between source and display without the guesswork of generic alternatives. For integrators wiring ATEN KVM infrastructure or control-room display arrays, using the manufacturer-matched cable eliminates connector compatibility variables at commissioning time.
Compatibility
Designed to pair with ATEN DisplayPort-equipped KVM switches and peripheral sharing devices including the CS series multi-port KVM switches and VM-series matrix switches that carry DisplayPort I/O. Also compatible with any standard DisplayPort 1.2-compliant source or display — workstations, servers with discrete GPU outputs, and video and display equipment using full-size DisplayPort connectors. Verify your KVM model's port type before ordering: ATEN ships separate cables for HDMI, DVI, and VGA interfaces — this cable is DisplayPort-specific and not interchangeable with those variants. Consult your KVM switch model's spec sheet to confirm DisplayPort port presence.
Installation Notes
Route the 10-foot run with gentle bends — DisplayPort connectors are latch-lock style and should be seated until the retention clip audibly clicks. Avoid sharp 90-degree bends within 6 inches of either connector housing, which can stress the internal conductor terminations over time. In rack environments, use a cable management arm to prevent repeated flex stress on the connector boot. The latch-release tab must be depressed before removal — forcing the connector without releasing the latch risks damaging the port on the host device.
