Valcom V-CA2924 24 Station Cable Adapter
The V-CA2924 is a 24-station cable adapter built for consolidating paging and intercom wiring runs at a central wall-mounted point. Instead of homerunning individual station cables to a punch block or splicing them in a junction box, the V-CA2924 gives you a single wall-mounted termination point for up to 24 stations — the practical choice when you're wiring a paging intercom system across multiple rooms, floors, or wings and need a clean, serviceable wiring closet instead of a tangle of field splices.
Overview
Station cabling for large paging deployments gets messy fast once you're past a handful of zones. The V-CA2924 addresses that by centralizing 24 station connections in one wall-mounted enclosure, which cuts down on troubleshooting time later — if a station drops, you're checking one panel instead of tracing cable through walls and ceilings. It supports microphone-equipped stations, so it fits paging setups that include talkback or two-way audio zones, not just one-way speaker paging.
Compatibility
The V-CA2924 is built for Valcom paging and intercom systems using station-level wiring, and it's commonly deployed alongside paging horns and accessory hardware such as wire guards, universal paging interfaces, and cable splice boxes from the same product line. If you're speccing a full zone, plan the adapter alongside your structured cabling layout before pulling wire — retrofitting a consolidation point after the run is in the wall costs real labor.
Installation Notes
This is a wall-mount unit — confirm you've got a clean, accessible mounting location near your wiring path before rough-in. At 6.25 lb, it's light enough for standard wall anchors, but plan the mounting location during the cabling design phase covered in a PoE and cabling planning guide rather than as an afterthought.
What's in the Box
- 1x V-CA2924 24 Station Cable Adapter
