Ubiquiti UACC-CABLE-PT-1.5M DC Outdoor Power Cable
The Ubiquiti UACC-CABLE-PT-1.5M is a 1.5-meter outdoor DC power transport cable purpose-built for distributed network deployments where equipment sits beyond the main cabinet or power source. If you're mounting access points, radios, or security devices on roofs, poles, or exterior walls, this cable bridges that gap without forcing a secondary power supply into the field.
Key Features
- UV-Resistant Jacket: The cable withstands prolonged direct sunlight without cracking or degrading — a mandatory feature for any outdoor run lasting more than a season. Standard PVC fails in 12–24 months under UV load; UV-formulated jackets extend serviceable life to 5+ years, reducing premature replacement costs and field visits.
- Power Transport Connector (Both Ends): Male connectors on each end integrate directly with Ubiquiti UISP infrastructure and compatible outdoor equipment. No adapters needed — you plug source to device and move on. This connector standard is proprietary to Ubiquiti, so verify your power supply and remote device both carry the matching connector before ordering.
- 1.5-Meter Length: Covers mid-range runs from a cabinet to a rooftop or from a pole base to mounted radio. Longer than a standard patch cable, shorter than a 10m run. If your distance exceeds 1.5m, you'll need a longer variant or a secondary power supply closer to the load.
- Outdoor-Rated Construction: Designed to tolerate temperature swings, moisture, and salt air in coastal or industrial environments. Not submersible — avoid full water immersion or extended pooling at connectors.
- DC Power Delivery: Carries DC voltage and current for remote PoE injectors, power supplies, and outdoor networking gear. Current capacity is standard for Ubiquiti outdoor deployments; verify your device's power draw against the supply's rated output to avoid undersizing.
- No In-Line Components: This is a direct cable run. No surge protection, no filtering, no termination box — simplicity and reliability, assuming your supply and device are properly grounded upstream.
Integration & Compatibility
The UACC-CABLE-PT-1.5M integrates with Ubiquiti UISP and outdoor networking infrastructure that specifies Power Transport connectors. Before deployment, confirm both your power source (typically a PoE injector or outdoor power supply) and your remote device (access point, radio, security camera) carry male Power Transport connectors. If either end uses a different connector type (such as barrel DC or Ubiquiti's older proprietary standards), this cable will not connect. Consult your supply and device datasheets or contact Ubiquiti support to verify compatibility.
For large multi-site deployments, refer to PoE and power planning guides to size your centralized power supplies and route cable runs efficiently across multiple outdoor devices.
Frequently Asked Questions
Q: Is the UACC-CABLE-PT-1.5M suitable for direct burial or conduit runs?
A: The cable is rated for outdoor surface exposure and mounted runs (roof, pole, wall). Burial or extended underground use is not recommended without protective conduit. For buried runs, use a dedicated underground cable rated for that environment.
Q: What is the maximum current this cable can safely handle?
A: The cable is designed for standard Ubiquiti outdoor device power consumption (typically under 100W for remote access points and radios). Verify your specific device's maximum power draw in its datasheet. Do not exceed the power supply's rated output.
Q: Can I use this cable indoors?
A: Technically yes, but it is engineered and priced for outdoor use. Indoor deployments would benefit from standard indoor-rated DC cables at lower cost.
Q: Does the UACC-CABLE-PT-1.5M come with surge protection?
A: No. This is a passive cable. Surge protection and overcurrent protection must be implemented at the power supply or via a separate surge suppressor in the same cabinet.
Q: What is the operating temperature range?
A: The cable is rated for standard outdoor temperature ranges typical of Ubiquiti outdoor devices. Verify the specific supply and remote device datasheets for their operating limits; the cable itself will withstand broader extremes than the electronics it connects.
Q: Is there a longer variant of this cable?
A: The UACC-CABLE-PT-1.5M is a 1.5-meter fixed length. Ubiquiti manufactures other lengths in the same family; consult the full catalog or contact your supplier for alternate lengths.
James EverettPerspective based on aggregated IP Security Depot and affiliated engineering team experience.
The UACC-CABLE-PT-1.5M solves a specific problem: outdoor installations where your power source lives in a protected cabinet and your radio or access point sits on a roof or pole 1.5 meters away. The UV-resistant jacket is not cosmetic — it's the difference between a cable that works for five seasons and one that cracks and leaks after two. Standard PVC degrades fast under direct sun; this cable won't.
Technical Highlights:
- UV-Resistant Jacket: Extends outdoor lifespan from 12–24 months (standard PVC) to 5+ years under continuous sunlight exposure. Reduces unplanned field visits for cable replacement.
- Power Transport Connector (Male–Male): Direct integration with Ubiquiti UISP supplies and compatible outdoor devices. Eliminates adapter chains and connection points that invite corrosion and intermittent failures in wet environments.
- 1.5-Meter Fixed Length: Bridges rooftop-to-cabinet and pole-mount-to-base distances without excessive slack (which collects water) or tension that stresses connectors over time.
Deployment Considerations:
- Connector Verification Is Non-Negotiable: This cable has male Power Transport connectors on both ends. If your power supply or remote device uses a different connector type (barrel connectors, Anderson PowerPole, or older Ubiquiti proprietary standards), this cable will not mate. Verify compatibility before ordering — a wrong connector can delay a site deployment by days.
- No Surge Protection Built In: Long outdoor cable runs are lightning-strike vectors. If your site sits in a high-strike zone (elevated terrain, coastal areas), implement surge suppression at the power supply cabinet, not at the device end. The cable itself is passive and cannot protect against transient voltage spikes.
Deploy this cable on rooftop and pole-mounted Ubiquiti access points, radios, and outdoor PoE injectors where your power source is in a weatherproof cabinet 1.5 meters away. Skip it if you need longer runs (order a longer cable variant) or if your device uses a different connector family.
