Ubiquiti U-CABLE-PATCH-3M-RJ45 Cat6 Patch Cable
Overview
The U-CABLE-PATCH-3M-RJ45 is a 3-meter Cat6 patch cable with male RJ-45 connectors on both ends, designed for UniFi network deployments. The white cable provides reliable wired connectivity between network switches, PoE injectors, access points, and inline infrastructure devices. At 3 meters, it bridges standard rack-to-device runs and inter-cabinet connections without excess coil bulk — long enough for typical vertical cabinet spacing and horizontal equipment layouts, short enough to avoid cable management clutter.
Compatibility
This cable integrates with all UniFi networking equipment including UniFi switches, PoE injectors, access points, and gateway devices. It supports 10/100/1000Base-T Ethernet standards (Gigabit), making it suitable for both powered and unpowered connections. The standard RJ-45 male connectors are compatible with any device featuring a standard Ethernet port — not limited to Ubiquiti hardware, though designed as part of the UniFi ecosystem. Use this cable for equipment interconnects, patch runs between PoE switches and access points, or uplinks to core network infrastructure.
Installation Notes
Cat6 cables perform best when bent at radii larger than 1 inch (25mm) — sharp kinks can degrade signal integrity over the 3-meter span. Avoid bundling with high-current power cables; maintain separation from AC mains to prevent electromagnetic interference. The cable is rated for standard office and light commercial indoor environments; do not expose to direct sunlight or high moisture without additional conduit protection.
